Delta Dore Tyxal+ DFR Manual


Læs gratis den danske manual til Delta Dore Tyxal+ DFR (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Delta Dore Tyxal+ DFR, eller vil du spørge andre brugere om produktet?

Side 1/5
Lithium 9Vdc - Lithium CR123 3 Vdc
Consumption stand-by : 2 µA
Consumption : 16,2 mA max.
85 dBA max. - 3 m.
X3D alarme : [868 – 868.6] MHz et
[868.7 – 869.2] MHz
100 m Ý 300m
Maximum power radio < 10 mW
Receiver category: 2
-10°C / +70°C
0°C / +50°C
IP IP 30 - IK 04
75%
Ø 110 x 40 mm
Important product
information ( )Ì
164 gr.
Important
Product
Informations
Piles à l’intérieur / Batteries
inside /
Mit Batterien / Pile all’interno /
Pilas en el interior /
/ Batterijen binnenin
Contenu / Contents / Inhalt /
Contenuto / Contenido /
/ Inhoud
DFR TYXAL +
EN Smoke detector
* Up to 10 years valid under the conditions of use specied in the
installation instructions and the General Conditions of Sale
Instructions
EN14604: 2005 + AC2008
“Conforme au référentiel NF DAAF”
(15)
n° DoP 0333-CPR-292119-1
www.marque-nf.com
- 2 -
1. Presentation
2. Location
Locations to avoid
Do not install the detector:
• Within a metre from vents for heating, cooling or circulating air.
The smoke could be blown away from the detector or be diluted.
• In a place where the temperature could drop beneath 0°C or rise above
+50°C; risk of detector not working correctly.
• In a place where there is a risk of condensation. Bathrooms and laundry
rooms are not recommended.
• Places where smoke could gather (kitchen or poorly ventilated garage) and
cause false alarms.
• In a place that is excessively dusty.
Do not install in non-converted attics.
Additional installation recommendations, as well as the "Mandatory
Performance Declaration" for this equipment are available in the
product le for on our website www.deltadore.comDFR T YXAL+
Material manufactured by SHD BP10809 under reference DOF79R.
The detector can be associated with a DELTA DORE wireless X3D alarm and
control system.
Functional check and maintenance:
You must check that your detector is functional once a
month or after each battery change.
Pressing the “test” button on the case for a few seconds
will light up the LED and the detector will emit 3 beeps.
Quick fl ashing from the detector means that it has
switched to pre-alarm mode (multiple readings).
If the detector’s sensors confi rms the presence of
smoke, the alarm will be activated.
Do not try to trigger the alarm any other way (using a lighter, etc.) because you
could damage the detector or even start a fi re.
Your detector has been designed to require the minimum maintenance possi-
ble. However, some simple actions need to be performed once a year.
After having removed the detector:
• Clean the cracks in the detector (located on the side) with a vacuum clean-
er, using a soft brush or a vacuum cleaner accessory.
• Use a slightly damp cloth to clean the outside of the case.
• Do not blow on the detector to avoid lifting dust.
It is recommended that the detector be replaced after 10 years.
2. Location


Produkt Specifikationer

Mærke: Delta Dore
Kategori: Ikke kategoriseret
Model: Tyxal+ DFR

Har du brug for hjælp?

Hvis du har brug for hjælp til Delta Dore Tyxal+ DFR stil et spørgsmål nedenfor, og andre brugere vil svare dig