Desa SL-6168 Heath Zenith Manual

Desa Dørklokke SL-6168 Heath Zenith

Læs gratis den danske manual til Desa SL-6168 Heath Zenith (20 sider) i kategorien Dørklokke. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Desa SL-6168 Heath Zenith, eller vil du spørge andre brugere om produktet?

Side 1/20
© 2003 DESA Specialty Products™ 595-5724-03
Wireless
Door Sensor
Chime
Model SL-6168
Your doorbell includes:
Plug-in doorbell chime
Door sensor/transmitter with
battery
Door magnet
Magnet spacer
Hardware pack
To reduce the risk of electrical shock, this equipment has a polarized
plug (one blade is wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
Chime
Volume
Control
1. Set the chime volume on the
back of the plug-in chime, if
desired.
2. Plug-in the doorbell chime.
Downloaded from www.Manualslib.com manuals search engine
-2-
595-5724-03
Use either screws or double-sided tape to mount the magnet
and transmitter.
Attach the back of the case to the door jamb or wall. Snap
the front of the transmitter and magnet back on.
When attaching the magnet or transmitter
using the double-sided tape, make sure the
surface is clean.
Installation
Important considerations: The sensor/transmitter must be mounted to the
door jamb. The magnet should be attached to the door. To prevent vandalism
and increase battery life, the sensor/transmitter should be installed inside.
Test the location of the sensor/transmitter. Hold
the transmitter on the door jamb with one hand,
and the magnet with the other as shown. Take
the magnet away, and the chime should sound.
Alignment Marks
To install the battery in the transmit-
ter remove the back of the case
by pushing in the tab on the bot-
tom with a small screwdriver
and rotating the blade.
Install an alkaline type A23 12 Volt battery. The positive terminal should be
positioned as shown.
The edge of the magnet must be within 2 (13 mm) in. of the edge of the
transmitter, the alignment marks must be positioned as shown, and the front
surfaces of the magnet and transmitter should be as nearly flush with each
other as possible. It may be necessary to use the spacer under the magnet
to obtain the correct spacing.
Downloaded from www.Manualslib.com manuals search engine


Produkt Specifikationer

Mærke: Desa
Kategori: Dørklokke
Model: SL-6168 Heath Zenith

Har du brug for hjælp?

Hvis du har brug for hjælp til Desa SL-6168 Heath Zenith stil et spørgsmål nedenfor, og andre brugere vil svare dig




Dørklokke Desa Manualer

Dørklokke Manualer

Nyeste Dørklokke Manualer