Doktorvolt Wallbox basic Manual


Læs gratis den danske manual til Doktorvolt Wallbox basic (7 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Doktorvolt Wallbox basic, eller vil du spørge andre brugere om produktet?

Side 1/7
Wallbox
BASIC
EN
DE
PL
2
WALLBOX charger for EV
DV-9109-EV
The charger should be disconnected from the power source before installation, configuration or
Installation should only be performed by a qualified installer in accordance with local electrical
regulations!
0. Preparation
Before starting, always ensure that the device is shut down.
1. Open the housing
Remove the 6 screws holding the top of the housing to the base.
Gently open the case.
2. Wall mounting
Refer to the attachment included to the manual
3.
Power supply
3.a
The Wallbox charging station does not have its own electrical protection
devices. The supply cable to the charger must be protected by an
overcurrent circuit breaker and a residual current circuit breaker (at least
type A with a tripping current of 30 mA) and miniature circuit breaker. No
other circuits may be connected to the same protection devices
The device incorporates additional means of protection against DC
residual current (>6 mA DC). In addition, follow the vehicle manufacturer's
recommendations.
The residual current device and the overcurrent protections should be
selected according to the controller's charging current setting
EN


Produkt Specifikationer

Mærke: Doktorvolt
Kategori: Ikke kategoriseret
Model: Wallbox basic

Har du brug for hjælp?

Hvis du har brug for hjælp til Doktorvolt Wallbox basic stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Doktorvolt Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer