Dormakaba DKPS-2A Manual

Dormakaba Ikke kategoriseret DKPS-2A

Læs gratis den danske manual til Dormakaba DKPS-2A (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Dormakaba DKPS-2A, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

INSTALLATION

DKPS-2A

POWER SUPPLY / RGER FOR CHA ACCESS CONTROL AND EGRESS DOORS

ISDKP S-2

10.

11.

12.

13.

14.

15.

16.

17.

19.

20.

21.

22.

This power supply should be installed i compliance with the National Electricaln

Code(NFPA 70) CSA C22.1, Canadian Electrical Code, Part 1 and all applicable

Local Codes. Installation t performed by suitably qualified technicalo be

personnel.

Description

The DKPS-2A is a power supply/charger that supplies a total of 2.5 amps

nominal continuous supply current at nominal 12/24VDC outputs. There are

4 outputs lock for Magnetic or door strike each with electronic over-current

protection @ 2 Amp. It is installed in a large mild steel metal enclosure capable

of accommodating two 7AH or 12AH lead-acid batteriesrechargeable

. These are

monitored Power Supplies for use in Access Control and Egress Doors.

Listed under UL294, CAN/ULC-60839-11-1 and CAN/ULC-S533.

Battery load test every 48hr.

Battery Charger test every 48hr.

Battery Reversal protection.

Low Battery indication at 11.40/22.80 Volts

Low Battery disconnec at 10.10/20.30 Volts.t

Automatic switch over to stand-by battery upon AC Failure.

Common “Batt.Fault” CMOS relay for all battery and charger fault.

CMOS relay output for AC failure within 60 seconds.

LEDs display on enclosure door (LEDs, Green, Yellow).

Common “Out Fault” CMOS relay for DC failure on any of the 4 outputs.

Battery charging leads included.

Board Dimension: 195mm x 110mm

Enclosure Dimension: 338mm x 448mm x 110mm.

AC input indication by Green LED. (LED on when AC i present). s

1. Input = 100-240VAC, 50-60Hz. 2.4A Max draw.

2. Output 2.5 Amps continuous supply current at Nominal 12/24 VDC

controlled outputs and one auxiliary output.

3. 4 Magnetic Lock or 4 Strikes outputs each, with electronic over-current

protection set at 2 Amp.

4. Built-in dedicated charger for lead acid or gel cell type sealed batteries.

5. Maximum battery charging current Amps1

6. Yellow LED for Battery Fault indication including charger failure monitor.

7. Battery 10 presence detection within seconds.

PART NO:DM2000 Ver.02

General Specifications:

www. .us • one: 1.80 . 0 • Fax: 8 2.9 5 • Edormakaba Ph 0.265 663 1. 00.48 79 -mail: sales_R @ .comCI dormakaba R01-20GB

Technical Specification:

Controlled Outputs(4)

Charging Current Max. 1Amp

Operating Temperature 0 deg.C to 49 deg.C

LED Indications

1. Green LED - AC indicator

a. On when AC present.

b. The normally closed (NC) AC Fault CMOS Relay activates(open) within 60

seconds after AC failure.

2. Blue LED – DC Power indicator

a. Powered directly from the power supply DC output and indicates output is

present. Blue LED will be OFF when no DC is present.

3. Yellow LED – Battery Charger and Fault indicator

a. The Yellow LED indicates various Battery Fault Conditions and Indication.

4. Red LED –Battery Test indicator.

a. The Red LED indicates a Battery test Failure or a Battery charger Failure in

eht eeS .snoitidnoC tluaF rehto etacidni ot DEL wolleY eht htiw noitcnujnoc

Fault Conditions and Indication Table for details.

5. Red Led on individual output indicator

a. There are 4 Red LEDs indicating that the outputs are ON when lit.

See the table Fault Condition.

Nominal 12 VDC or 24 VDC,

Max.13.80 VDC or 27.60 VDC, Min. 11.40 VDC or 22.80 VDC

Max. 500mA each

Auxiliary Output

Reset & Fire Trigger Input Max. Wire Resistance 100 ohm

Nominal 12 VDC or 24 VDC,

Max.13.80 VDC or 27.60 VDC, Min. 11.40 VDC or 22.80 VDC

Max. 500mA

Model Line Security

Performance Ratings

Product Type Destructive Attack Endurance Standby Power

Power Supply I I IV

UL 294 Performance Levels:

Model GradeProduct Type

Power Supply 3 (when used with 7AH battery)

4 (when used with 12AH battery)

III (when used with

7AH battery

IV (when used with

12AH battery

CAN/ULC-60839-11-1 Performance:

Grade Achievement

To achieve Grade 3 or 4 connects,

the Trouble AC & Battery Relay

Outputs to a Grade 3 or 4 Control

Unit.

DKPS-2A

Produkt Specifikationer

Mærke:	Dormakaba
Kategori:	Ikke kategoriseret
Model:	DKPS-2A

Har du brug for hjælp?

Hvis du har brug for hjælp til Dormakaba DKPS-2A stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Dormakaba Manualer

Dormakaba Keyscan EC1500 Manual

21 August 2024

Dormakaba RCI S2500A Manual

21 August 2024

Dormakaba EAC Manual

21 August 2024

Dormakaba CLM9000 Manual

21 August 2024

Dormakaba DKX Type III Manual

21 August 2024

Dormakaba 9800 Manual

21 August 2024

Dormakaba HSW-GP Manual

21 August 2024

Dormakaba DKX-10 Manual

21 August 2024

Dormakaba Confidant RFID Kit 1 Manual

21 August 2024

Dormakaba DKX Type IV Manual

21 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Playtive IAN 332975 Manual

16 Juni 2025

Playtive HG05527 Manual

16 Juni 2025

Philips 75PUH6393 Manual

16 Juni 2025

Foster Slimline FSL400L Manual

16 Juni 2025

Playtive HG04098 Manual

16 Juni 2025

Aiphone JPW-BA Manual

16 Juni 2025

Life On Products LCAF020 Manual

16 Juni 2025

Hager CEA263U Manual

16 Juni 2025

Moulinex Illico DJE241 Manual

16 Juni 2025

Foster Slimline FSL800M Manual

16 Juni 2025