Dormakaba ES84 Manual

Dormakaba Ikke kategoriseret ES84

Læs gratis den danske manual til Dormakaba ES84 (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 21 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 11 anmeldelser. Har du et spørgsmål om Dormakaba ES84, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

USA: DORMA DRIVE, DRAWER AC, REAMSTOWN, PA 17567 PHONE: (800) 523-8483 (717) 336-3881 FAX: (717) 336-2106

EMAIL: archdw@dorma-usa.com dorma-usa.com WEBSITE:

1. Determine the vertical centerline of the door lock face and

the horizontal centerline of the latch.

IMPORTANT: When determining the horizontal centerline

observe the following:

FOR MORTISE LOCKS: Align the angled ramps of the lip

bracket with the deadlock trigger of the mortise latch.

FOR CYLINDRICAL LOCKS: Align the center of the latch with

the center of the strike opening.**

2. Transfer both the horizontal and vertical centerlines to the

doorframe.**

3. Prepare the doorframe for cutting as shown in the

appropriate drawing.

4. If required, install the ‘no weld’ mounting tabs per page 4.

5. Attach the strike faceplate to the lip bracket with the self-

tapping screws provided. (It may be desirable to leave

these screws slightly loose to facilitate insertion into the

doorframe.

6. Connect the incoming wiring from the power supply (see

wiring instructions).

7. Install the door strike in the doorframe using the screws

provided.

Instructions

MEASUREMENT

FRACTIONAL

INCHES

DECIMAL

INCHES

METRIC

A 1-1/4 1.250 31.75

B 4-7/8 4.875 123.83

C 3-3/8 3.375 85.73

D 1-3/16 1.188 30.16

E 3/8 .375 9.53

F 1/8* .125* 3.18*

G 1-11/16 1.688 42.86

R 5/32 0.156 3.97

K 4-1/8 4.125 104.78

M 12-24 — —

Vertical Centerline

of Door**

Aluminum Frames 1-3/16”D

Modular ES86 FSV ES86 FSV LKM or or

ES86 U assembled with 86S4 faceplate

Aluminum Frames 1-1/16”D

Modular ES84 FSV ES84 FSV LKM or or

ES84 U assembled with 86S4 faceplate

MEASUREMENT

FRACTIONAL

INCHES

DECIMAL

INCHES

METRIC

A 1-1/4 1.250 31.75

B 4-7/8 4.875 123.83

C 3-3/8 3.375 85.73

D 1-3/32 1.094 27.78

E 3/8 .375 9.53

F 1/8* .125* 3.18*

G 1-11/16 1.688 42.86

R 5/32 0.156 3.97

K 4-1/8 4.125 104.78

M 12-24 — —

Vertical Centerline

of Door**

NOTE: Specifications subject to change without notice.

* Dimension F is measured from face of mounting tab to face of frame.

** Dimension X on the drawing is determined by the vertical centerline of the door. If the latch incorporates a deadlocking pin additional steps will be