with Sidelites Installation Instructions
Table of Contents
Table of contents
1 Technical specifications 3
1.1 Overview 3
1.1.1 General information 3
1.1.2 Intended use 3
1.1.3 Glass requirements/fittings/mounting 3
1.1.4 Requirements for glass panel 3
1.1.5 Safety instructions 3
1.1.6 Symbols used - Safety/Installation 3
1.1.7 Maintenance, care, repair 3
1.1.8 Disposal 3
1.2 Specification - technical data 4
1.3 Tempered laminate glass (TLG) and
adhesive specifications 4
2 Installation preparation 5
2.1 Overall 5
2.2 Door/wall dimensions 6
3 Installation instructions -
Slow moving panel (SMP) 7
3.1 Installing end stops in SMP 7
3.2 Securing gasket to SMP track 7
3.3 Securing sidelite section profile to SMP track 8
3.4 Specifications for securing track to
mounting surface 8
3.5 Installing U-Channel for sidelite 9
3.6 Installing sidelite glass 9
3.7 Installing sidelite glass filler panel 10
3.8 Installing sidelite glass gasket 10
3.9A Installing roller carriers: on SMP
monolithic glass ONLY 11
3.9B Installing roller carriers:
on SMP tempered laminate glass ONLY 12
3.10 Adjust roller carrier wheels 13
3.11 Disengage the anti-jump 13
3.12 Assemble simultaneous drive 14
3.13 Secure moving floor guide 15
3.14 Install glass/rollers in SMP track 16
3.15 Install floor guide 16
3.16 Install floor guide: continued 17
3.17 Engaging anti-jump 17
3.18 Adjustment door height 17
3.19 Adjustment end stop location:
LEADING end stop
Adjustment end stop location:
TRAILING end stop 18
4 Installation instructions -
Quick moving panel (QMP) 19
4.1 Installing end stops in QMP 19
4.2 Connecting the doors via the cable bracket 19
4.3 Securing track for QMP 20
4.4 Secure clamp profile for QMP 21
4.5 Install hook set (less Dormotion) 21
4.6 Installing roller carriers 22
4.7 Installing DORMOTION start/stop (optional) 23
4.8 Disengaging the anti-jump 23
4.9 Install glass/rollers in QMP track 24
4.10 Engaging anti-jump 24
4.11 Align the cable 25
4.12 Adjustment end stop location:
LEADING end stop
Adjustment end stop location:
TRAILING end stop 26
4.13 Securing the cable to the QMP cable clamp 27
4.14 Install DORMOTION unit into
QMP track (optional) 28
4.15 Adjust start/stop pin height (if necessary) 29
4.16 QMP track cover and end caps 30
4.17 SMP cover profile 31
4.18 Cover profile for passage 32
4.19 Cover clips 32
4.20 Cover spacers 33
4.21 Install brush profile 33
4.22 Secure system cover 34
