Ebm-papst 8214 JH4 Manual

Ebm-papst Ventilator 8214 JH4

Læs gratis den danske manual til Ebm-papst 8214 JH4 (5 sider) i kategorien Ventilator. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Ebm-papst 8214 JH4, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/5
page 1 of 5
Operating manual
8214 JH4
Product type, manufacturing date (calendar week/year of construction)
and if required, conformity mark can be found on the nameplate on the
product.
Please provide us with the contents of the nameplate when making
enquiries about the product.
ebm-papst St.Georgen GmbH & Co. KG
Hermann-Papst-Straße 1
D - 78112 St.Georgen
Phone: +49 (0) 7724 / 81-0
Fax: +49 (0) 7724 / 81-1309
info2@de.ebmpapst.com
www.ebmpapst.com
As per: 15.08.2012
Version 1 5
Article number: 9692910197
Original operating manual
INDEX
1 SAFETY REGULATIONS AND INFORMATION 1
2 INTENDED USE 3
3 TECHNICAL DATA 3
4 CONNECTION AND COMMISSIONING 3
5 FAULTS, POSSIBLE CAUSES AND REMEDIES 4
1 SAFETY REGULATIONS AND INFORMATION
Read the operating manual carefully before commencing work at the
product. Pay attention to the following warnings to avoid risk to
persons or malfunctioning.
This operating manual is an integral part of the product.
In the event of resale or change of ownership the operating manual
must accompany the product. This operating manual may be copied
and provided as information on potential risks and their avoidance.
Hazard classication of warning notices
The following risk ratings are used in this operating manual to denote
potential risk situations and important safety instructions:
DANGER
This is a potentially dangerous situation
and warns of an impending health risk
or risk of fatal injury if this warning is
not observed. Observe this warning.
WARNING
The dangerous situation can occur and
can result in major or fatal injuries if the
warning is not observed. Work with
extreme care.
CAUTION
The dangerous situation can occur and
can result in minor injuries or damage
to property if the warning is not
observed.
NOTE
A potentially dangerous situation can
occur and results in damage to
property if not avoided.
Qualication of personnel
Only skilled electricians are permitted to install the product, to carry out
the test run and to work at the electrical unit.
Only instructed and authorized skilled personnel are permitted to
transport, unpack, operate and service the product.
Basic safety regulations
Safety risks related to the product must be reassessed after installing
in the nal device.
The operating manual was developed in accordance with European
market requirements and may need adapting to the market
requirements of the country in question.
When working at the product, observe the following:
Do not make any changes to the product.
WARNING
Impermissible high load
Stop the product immediately after
impermissible loading (e.g. impact,
heat, overvoltage).
page 2 of 5
Electrical voltage and current
DANGER
Electrical voltage
Regularly check the electrical
equipment of the product.
Eliminate immediately loose
connections and defective cables.
Safety and protective functions
DANGER
Missing safety device and faulty
protective equipment.
Without protective equipment severe
injuries can occur, e.g. by taking hold of
the rotating equipment.
Operate the product with protection
guards only.
Electromagnetic radiation
Electromagnetic compatibility (EMC) may aect the system integration
of the product due to interaction.
Ensure the electromagnetic compatibility of the entire system.
Moving parts
DANGER
Self-starting product
If voltage is applied, the motor
automatically restarts after a mains
failure or when blocking has been
eliminated.
Do not stand in the danger zone of
the product.
Switch o the mains voltage when
working on the product and secure
against switching on again.
DANGER
Rotating impeller
Contact with the impeller may result in
injuries.
Before starting the product, ensure
that it is securelyxed and that the
guards are in place.
DANGER
Blocking of escape routes
The product can create dangerously
high pressure.
When operating the product ensure
that there is adequate supply and
exhaust air.
WARNING
Parts transported by the airflow
The product can transport small parts
in the airow and catapult them out.
Ensure that there are no loose
small-parts in the intake and
exhaust area.
Do not stand in the danger zone of
the product.
WARNING
Rotating fan
Long hair, loose-tting garments and
jewellery can be caught and pulled into
the product. Risk of injury.
Do not wear loose-tting garments
or jewellery when working on
moving parts.
Protect long hair by wearing a hair
net.
CAUTION
High risk of re spreading
Can cause re to spread.
Never direct the airow
(intake/exhaust side) at a potential
source of fire.
Hot surface
CAUTION
High temperature at motor housing.
Risk of burns
Provide adequate protection against
accidental contact.
Emission
DANGER
Acoustic alarms can be overheard.
Alarm signals can be overheard
Take technical protective measures,
e.g. optical warnings.
WARNING
A noise pressure level higher than
70dB(A) is possible depending on
the installation and operating
conditions.
Risk of deafness due to noise.
Take technical protective measures.
Provide operating personnel with
protective equipment, e.g. ear
protection.
Transport
Only transport the product in its original packaging. Secure during
transport.
The vibration values, temperature and climate ranges should not be
exceeded during transport.
Storage
Store the product in a dry and clean environment that is well protected.
Ensure that the storage temperature is adhered to,see Chapter 3,
Technical Data.If the product is not operated for a longer period of
time, we recommend running it for approx. 15 minutes annually to
move the motor bearings.
Cleaning
NOTE
Product damaged during cleaning
Clean the product carefully with a
moist cloth without applying
pressure to the rotor. Do not use
cleaning agents that contain acids,
caustic solutions or solvents.
Disposal

Produkt Specifikationer

Mærke: Ebm-papst
Kategori: Ventilator
Model: 8214 JH4

Har du brug for hjælp?

Hvis du har brug for hjælp til Ebm-papst 8214 JH4 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ventilator Ebm-papst Manualer

Ebm-papst

Ebm-papst 3314 NN Manual

6 September 2024
Ebm-papst

Ebm-papst 8412 NLE Manual

3 September 2024
Ebm-papst

Ebm-papst 4118 N/2H8P Manual

3 September 2024
Ebm-papst

Ebm-papst 8218 JH4 Manual

3 September 2024
Ebm-papst

Ebm-papst 8214 JH4 Manual

3 September 2024
Ebm-papst

Ebm-papst 3412 NG Manual

3 September 2024
Ebm-papst

Ebm-papst 3214 JH4 Manual

3 September 2024
Ebm-papst

Ebm-papst 3212 JH4 Manual

3 September 2024
Ebm-papst

Ebm-papst 3218 JH4 Manual

3 September 2024
Ebm-papst

Ebm-papst 8212 JH4 Manual

2 September 2024

Ventilator Manualer

Nyeste Ventilator Manualer

Midea

Midea FT45-14AP Manual

1 August 2025
Meaco

Meaco Fan Sefte 8" Manual

1 August 2025
Meaco

Meaco Fan Sefte 10" Manual

31 Juli 2025
Frigidaire

Frigidaire FCVW3662AS Manual

31 Juli 2025
Javalo Elf

Javalo Elf Modern Collection JE-CF017D Manual

31 Juli 2025
RYOBI

RYOBI ONE+ RF18 Manual

31 Juli 2025
Brandson

Brandson 307361 Manual

31 Juli 2025
Meaco

Meaco Fan 1056 Manual

31 Juli 2025
Brandson

Brandson 307510 Manual

31 Juli 2025
Koenic

Koenic KSF 400-M Manual

31 Juli 2025