Ei Electronics Ei170RF Manual

Ei Electronics Ikke kategoriseret Ei170RF

Læs gratis den danske manual til Ei Electronics Ei170RF (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 42 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 21.5 anmeldelser. Har du et spørgsmål om Ei Electronics Ei170RF, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

Strobe Light & Vibration Pad Module

Deaf & Hearing Impaired

RadioLINK Alarm System

For use with RadioLINK Smoke/Heat/Fire Alarms

(Smoke / Heat / Fire Alarm

supplied separately)

Note: At least one RadioLINK Smoke/Fire/Heat Alarm is required to make the Ei170RF

Alarm operational. This is not supplied with the Ei170RF and must be obtained separately.

Important: Read these instructions, together with those from the separate RadioLINK

Smoke/Heat/Fire alarms and accessories before installation. All instruction leaflets must be

left with the end user after installation.

Model: Ei170RF

The Ei170RF is for use with the following Ei RadioLINK Smoke/Fire/Heat Alarms and Accessories.

Mains Multisensor/Smoke/Heat/Fire Alarms:

Ei2110, Ei160RC & Ei140 Series Alarms in conjunction with an Ei168RC RadioLINK Base.

Battery Powered Smoke / Heat Alarms:

Ei3100RF, Ei3103RF, Ei3105RF, Ei405, Ei405TY, Ei605C (with RF module), Ei605TYC (with RF module).

Accessories:

Ei407 Manual Call Point, Remote Control (wall mounted),Ei410 Remote Control (portable), Ei411H

Ei428 Ei408 Relay Module, Switched Input Module, Ei170RFS Strobe Panel

1. INTRODUCTION

This leaflet describes the installation of the Ei170RF and its integration into a total RadioLINK Fire

Alarm System, incorporating a choice of Smoke/Fire/Heat Alarms and Accessories.

N.B. It is essential that the Ei170RF is connected to the mains to preserve its one-week battery

standby. Leaving the unit operating without mains connected will completely deplete the battery and

possibly damage it. (If the Ei170RF is not being used for a prolonged period and cannot be left plugged

in to the mains, then disconnect the battery).

Location

The Strobe Module should normally be fixed such that the internal strobe light can be seen from the bed,

and the vibration pad can be placed under the mattress or pillow. It has to be powered from the mains

(230VAC) so a suitable socket or junction box must be available to which it can be permanently connected.

The back-up battery in the Strobe Module must not be exposed to excessive heat such as sunshine,

heaters, fires or the like.

The associated RadioLINK Alarms and Accessories must be located and installed as described in

their own instruction leaflets.

2. INSTALLATION

Strobe Module Ei170RF

The battery must first be installed in the Strobe Module. Open the rear compartment by squeezing

together the two latches as shown in Figure 1b, and lifting the cover off.

Auxillary

Sockets

Vibration Pad

Primary

Mounting

Screw

Holes

Wire

Channels

for mains lead &

Vibration Pad

(and accessories

if required)

ode

l: Ei17

r u

with R

LINK

NK Fir

rm P

l f

Deaf & Hard of Hearin

Connect battery plu

& then plu

in mains.

After installation, house code system by pressin

house

code

wit

riv

imil

Squeeze

Here

Squeeze

Here

Battery

Cover

Figure 1b

Squeeze as shown to open

battery compartment

Figure 1a

Produkt Specifikationer

Mærke:	Ei Electronics
Kategori:	Ikke kategoriseret
Model:	Ei170RF
Produktfarve:	Hvid
Batteriteknologi:	Blybatterier (VRLA)
Relativ luftfugtighed ved drift (H-H):	15 - 95 %
Driftstemperatur (T-T):	0 - 40 °C
Indikator for batteriniveau:	Ja
Materiale:	Plast
Forbindelsesteknologi:	Trådløs
LED-indikatorer:	Status
Strømkilde type:	Vekselstrøm
Kan forbindes indbyrdes:	Ja
Monteringstype:	Væg
Indgangsspænding:	230 V
Mængde af sammenkoblede alarmer (maks):	12
Kompatible produkter:	Ei3100RF, Ei3105RF, Ei3103RF, Ei405, Ei405TY, Ei168RC, Ei410,\nEi411H. Ei428, Ei407,Ei174, Ei178
Indgangsfrekvens:	50 Hz
Backup batteri:	Ja
Signaltype:	Vibrationssignal
Vibrerende pude kompatibel:	Ja
Blinkende blitz:	Ja
Frekvens:	868 Mhz
UL 94 antændelsesstandard:	V0