Ei Electronics Ei605MRF Manual

Ei Electronics Ikke kategoriseret Ei605MRF

Læs gratis den danske manual til Ei Electronics Ei605MRF (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Ei Electronics Ei605MRF, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

Instructions

Read and retain carefully for as long as the product is being used. It contains vital information on the operation and installation

of your Smoke Alarm. The leaet should be regarded as part of the product.

If you are just installing the unit, the leaftet must be given to the householder. The leaet is to be given to any subsequent user.

Ei605MTYRF Module Ei605MRF Module

RF Modules

for Battery Powered

Smoke & Heat Alarms

Ei600 Series

B16971-R0-Ei600 RF-U&C 28/6/10 12:13 PM Page 1

Introduction

Congratulations on purchasing an Ei600 Series RF RadioLINK module. These RF

modules can be easily installed in the Ei600 Series Alarm to provide you with an RF

interconnected fire warning system – when one Alarm senses fire and sounds a

warning, all the other Alarms will also sound a warning. This helps to ensure the

alarm sound will be heard throughout the property.

Installation

1. The Ei600 Series Alarm must be installed as per the guidance in the instruction

booklet ‘Battery Powered Smoke & Heat Alarms’.

2. Remove the RF module from the packaging and using the pull tag, carefully

insert into the back of the Alarm (see figure 1) - (some Alarm models may have the

RF Module already fitted).

3. Ensure that the battery is connected in the 9V Replaceable Battery Models.

House code the Alarms as follows:

4. Before fitting the Alarm to the mounting plate, press and hold the ‘House Code’

switch on the rear of the RadioLINK module until the red light comes on (see

Figures 2a) and then release.

5. Twist the Alarm onto its mounting plate.

6. Similarly press and hold the House Code switch on the second Alarm until its red

light comes on and then release. Twist the Alarm onto its mounting plate. Put all the

remaining alarms into House Code mode similarly and attach to the mounting plate

in the same manner in less than 15 minutes. (They automatically exit house code

mode after 30 minutes).

B16971-R0-Ei600 RF-U&C 28/6/10 12:13 PM Page 2

Produkt Specifikationer

Mærke:	Ei Electronics
Kategori:	Ikke kategoriseret
Model:	Ei605MRF
Produktfarve:	Grøn
Relativ luftfugtighed ved drift (H-H):	15 - 95 %
Driftstemperatur (T-T):	0 - 40 °C
LED-indikatorer:	Ja
Strømkilde type:	Batteri
Indgangsspænding:	9 V
RF-transmissionsfrekvens:	868 Mhz
Overfører strømområde:	- dBmW
Kapabilitet:	Ei605C