GB
Remote Controller (RCA-8N)
The Remote Controller is used to remotely arm or disarm the system, activate the panic alarm, and put the system in the "HOME"
mode.
I
Id
de
en
nt
ti
if
fy
yi
in
ng
g
t
th
he
e
p
pa
ar
rt
ts
s
BUTTON
Pressing this button will put the system into the Armed
mode.
BUTTON
Pressing this button for 3 seconds will trigger the panic
alarm regardless of whether the system is Armed,
Disarmed or Home.
BUTTON
Pressing this button will put the system into the Home mode.
BUTTON
Pressing this button will put the system into the Disarmed mode. If the alarm is sounding, pressing this button will stop
the alarm (except when the alarm situation was caused by pressing the Panic button on RCA-8N).
TX INDICATOR
BATTERY COMPARTMENT
1
2
3
4
5
6
TTXX IInnddiiccaattoorr
When any of these four buttons is hold the button until the TX LED is pressed, TX LED will on. Please
off to indicate the Remote Controller has successfully sent out a signal to the Main Unit.
<
<N
NO
OT
TE
E>
>
Press & hold the Panic button for one second then release. The Tx LED will light on for one sec., press & hold the
Panic Button (one sec) again
“CR2032” 3V 230 mAh Lithium battery as its power source. Battery life is over 2 years in a
normal domestic environment.
sent to the Control Panel along with regular signal transmission, and, the Control Panel will
display the status accordingly.
B
Ba
at
tt
te
er
ry
y
The Remote Controller uses one
The low battery status will be
G
Ge
et
tt
ti
in
ng
g
S
St
ta
ar
rt
te
ed
d
tery facing down.
then select “Add Device” menu.
Please refer to the operation manual of your control panel under the section of “Device +/-“ to complete learn-in process.
Remove the battery cover by using a coin to turn counter-clockwise.
Insert the battery as shown in diagram, with unmarked side (negative) of the bat
Replace the battery cover – secure the cover by using a coin to turn clockwise.
Put the Control Panel into “Device +/-“ menu and
Press any buttons on the Remote Controller.
