Electro-Voice EVA-1151D Manual

Electro-Voice Højttaler EVA-1151D

Læs gratis den danske manual til Electro-Voice EVA-1151D (2 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Electro-Voice EVA-1151D, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

EVA-AM

Attenuation Module

for EVA Loudspeakers

Installation Instructions

Tools Required:

1. Remove the input panel by removing the eight screws securing it.

2. Carefully unplug the crossover cable from the 10-pin header.

3. Unplug and discard the 7-pin jumper connector at the far end of the circuit board.

Instructions:

1. #2 Phillips Screwdriver 2. 3/16” (5mm) Flat Blade Screwdriver

3/16”

[5mm]

4. With the green circuit board on the

right, place the attenuation module

in the pocket provided for it on the

left with the lead wires from the

module pointing toward you.

5. Secure the EVA-AM mounting ears

to the four input panel bosses

with the four #10 screws provided.

Carefully tighten the screws evenly

in an X-cross pattern to avoid

warping the plastic input panel.

6. Plug in the 7-pin wiring harness

connector from the attenuation

module where the 7-pin jumper

was removed in step 3.

Figure 1:

Remove panel, unplug

crossover cable and jumper

Figure 2:

Attach module and plug in

7-pin module connector

7-pin

10-pin

12000 Portland Avenue South, Burnsville, MN 55337

Phone: 952/884-4051, Fax: 952/884-0043

www.electrovoice.com

Part Number LIT000310 Rev 2

U.S.A. and Canada only. For customer orders, contact Customer Service at:

800/392-3497 Fax: 800/955-6831

Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:

+ 49 9421-706 0 Fax: + 49 9421-706 265

Other Internatonal locations. For customer orders, Contact Customer Service at:

+ 1 952 884-4051 Fax: + 1 952 887-9212

For warranty repair or service information, contact the Service Repair department at:

800/685-2606

For technical assistance, contact Technical Support at: 866/78AUDIO

Specifications subject to change without notice.

Electro-Voice®

Important Note: Once an EVA-AM is installed, an attenuation level MUST be selected. (See step 9.)

If this wire is not connected, the entire loudspeaker in which the module is installed

WILL NOT FUNCTION!

7. Reconnect the 10-pin connector from the crossover and reinstall the input panel.

EVA-AM must be on the enclosure center-line to maintain horizontal center of gravity.

Do not install input panel backwards!

8. Apply the new label (supplied) over the input connectors.

Figure 3:

Reconnect crossover cable and

reinstall input panel

9. Connect one end of the blue wire (supplied) to the terminal marked “Select”. Set the

attenuation level for the module by connecting the other end of this wire to either the

-3 dB, -6 dB or -9 dB terminal, as determined by EVADA.

10. Connect the input lines to the module at the (+) and (-) terminals the same way you

would a standard non-attenuated EVA loudspeaker. The EVA-AM attenuates ONLY

the loudspeaker in which it is installed.

Figure 4:

Apply new label over connectors

Figure 5:

Connect input wires, set attenuation level, and

tighten unused screws

Tighten all unused connector screws to

prevent rattles!

Produkt Specifikationer

Mærke:	Electro-Voice
Kategori:	Højttaler
Model:	EVA-1151D

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro-Voice EVA-1151D stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Højttaler Electro-Voice Manualer

Electro-Voice EVH-1152S/99 Manual

22 Januar 2025

Electro-Voice XLE191-FG Manual

8 Januar 2025

Electro-Voice Sx600 Manual

8 Januar 2025

Electro-Voice Sb122 Manual

8 Januar 2025

Electro-Voice Tour X TX1122FM Manual

2 Oktober 2024

Electro-Voice EVID C10.1 Manual

2 Oktober 2024

Electro-Voice EVID-40C Manual

19 September 2024

Electro-Voice EVA-1151D Manual

16 September 2024

Electro-Voice EVC-1082-00 Manual

7 September 2024

Electro-Voice Sx100+ Manual

4 September 2024

Højttaler Manualer

Nyeste Højttaler Manualer

Sogo SS-8590 Manual

17 Juni 2025

Sogo SS-8790 Manual

17 Juni 2025

DS18 Hydro NXL-8M Manual

17 Juni 2025

Earthquake Sound PR-EQ5S8 Manual

17 Juni 2025

Sogo SS-8780 Manual

17 Juni 2025

DS18 PRO-X6.4BMRGB Manual

17 Juni 2025

DS18 PRO-X4.4BMSL Manual

17 Juni 2025

DS18 PRO-FU12.8 Manual

17 Juni 2025

DS18 GEN-X G4.6Xi Manual

17 Juni 2025

DS18 JL-SBAR.HT Manual

17 Juni 2025