Elro AS80PR11 Manual

Elro Sikkerhed AS80PR11

Læs gratis den danske manual til Elro AS80PR11 (4 sider) i kategorien Sikkerhed. Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om Elro AS80PR11, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

AS80PR11

PIR Motion Detector

Installation Instructions

General Introduction

This Detector is designed with a Passive Infra Red (PIR) sensor and light sensor in -

order to fulfill the purpose of security and home automation. It detects motion by

monitoring changes in infra red radiation levels emitted by body heat.-

Prepare a CR123A battery. Do not insert the battery into the unit yet.

Log into the ELRO Smart Home Alarm account from a web browser.

Select “System” then “Add a Device”.

Product Overview

LED

(hidden

behind

PIR lens)

LED Indication

PIR Lens

Tamper Switch

/ Link Key

Battery

Fixing Screw

Select “PIR Detector”.

Red LED

Used to indicate trigger events, low battery power, and warm up

Green LED

Used to indicate key learning controls

Orange LED

Used to indicate no codes learned

Binding

1. Undo and remove the fixing screw from the bottom of the detector. Carefully

pull the bottom of the detector away from the rear cover and then slide down to

release the top clips.

The following screen will appear. This means the gateway is entering binding

mode.

At this for point, insert the battery with correct polarity into the unit.

The screen below will appear in 10 seconds if the process is successful.

Time-out will occur if the binding process was unsuccessful. Please refer to the

“Manual binding” section.

Note: Leave the detector with the rear cover open to prepare for testing.

Manual Binding

Repeat steps 3 to 6 of the Binding with Homesys section.

With the battery inserted, press and hold the link key on the PCB for 3 or more

seconds, and the detector start LED will to flash, that has entered implying it ID

code learning mode.

Link key /

Tamper

The indicator stop flashing and LED will turn off within 5 seconds, indicating the

learning procedure is completed. The screen below will appear indicating the

process is successful.

If after 30 seconds the LED flashes rapidly (with an interval of 0.1 second) for 3

times, it means the PIR failed the binding process.

Operation & Testing

Warm- Up

It will take approximately 2 minutes to warm up the Detector after a battery is

inserted. During this period the LED will flash red slowly. When the LED turns red

for 5 secon up procedure is complete and the detector is ready ds, it implies warm-

for detection.

Testing

Go to System, and set it to ARM.

Wait for 30 secs then wave your hand in front of the detector.

If the test is successful the system will trigger an alarm (alarms are listed in

“Events”).

Note: It is necessary that the gateway is powered and connected to internet.

If the test is unsuccessful, please check the troubleshooting section.

Produkt Specifikationer

Mærke:	Elro
Kategori:	Sikkerhed
Model:	AS80PR11

Har du brug for hjælp?

Hvis du har brug for hjælp til Elro AS80PR11 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Sikkerhed Elro Manualer

Elro AB600P - MOTION DETECTOR Manual

17 September 2024

Elro AG40KE Manual

17 September 2024

Elro AG40PR Manual

24 August 2024

Elro ARD51 - V3 Manual

23 August 2024

Elro C903IP.2 Home Monitor Manual

23 August 2024

Elro C904IP.2 Home Monitor Manual

19 August 2024

Elro AS80RE11 Manual

16 August 2024

Elro C803IP.2 Home Monitor Manual

13 August 2024

Elro AP5500 - Pro Alarm System Manual

10 August 2024

Elro C703IP Manual

10 August 2024

Sikkerhed Manualer

Nyeste Sikkerhed Manualer

Aritech SHATTERPRO 3 Manual

15 Januar 2025

Axis Camera Station S9001 Mk II Desktop Terminal Manual

15 Januar 2025

Eminent EM6511 Manual

15 Januar 2025

Ranex RX2567-Z Manual

11 Januar 2025

NetworX NX-595E IP Communication Module Manual

5 Oktober 2024

Provision-ISR NVR2-4100P Manual

23 September 2024

Gira 0342 Manual

23 September 2024

Unitron Smart Alert Systeem Manual

23 September 2024

Netatmo Welcome Manual

21 September 2024

NetworX NX-408 Manual

20 September 2024