ELTA Music PF3 MK2 Manual


Læs gratis den danske manual til ELTA Music PF3 MK2 (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 2 anmeldelser. Har du et spørgsmål om ELTA Music PF3 MK2, eller vil du spørge andre brugere om produktet?

Side 1/6
MANUAL
PF3 MK2
CONTROLS
CV you can control/automate filter
cutoff via using in. Led indicator CV CV
mirrors the amount of voltage in the
input jack.
CV potentiometer attenuates applied CV
to the filter cutoff frequency.
CUTOFF – manual filter cutoff frequency
RESONANCE Filter resonance (boost
the frequency near cutoff point)
LP – low pass
BP – band pass
HP – high pass
N – notch filter
LEVEL controls the output level of
filtered signal to balance the volume.
DRY/WET blends dry and filtered
signals
CV in connect control voltage standart
mono minijack from eurorack system
LINK CV – when switched on links CV on
filter 1 to control both filters 1 and 2
LINK FREQ when switched on links
FREQ CONTROL on filter 1 to control
both filters 1 and 2
There is a noise generator built in the
filter. It can blend noise to the audio
signal
PINK/WHITE – switch two types of noise
LEVEL controls the level of noise
generator.
BALANCE adjusts amount of noise
signal going to filter 1 and 2
IN1 IN2 and this is an audio input of the filter. To operate in stereo or dual mono
mode plug in stereo of 2 mono signals here. If you plug just the and two IN1 OUT 2
filters are conneccted in series. If you plug input 1 and 2 and outputs 1 and 2 two filters
work in stereo (parallel mode). - switches on/off the unit. POWER ON POWER SUPPLY-
use 12VDC adapter 0,5 - 1 A (center positive)
FILTE MAIN FREQ CONTROLR 1 -
FILTER 2
NOISE


Produkt Specifikationer

Mærke: ELTA Music
Kategori: Ikke kategoriseret
Model: PF3 MK2

Har du brug for hjælp?

Hvis du har brug for hjælp til ELTA Music PF3 MK2 stil et spørgsmål nedenfor, og andre brugere vil svare dig