Emerson CK9902 Manual

Emerson Ikke kategoriseret CK9902

Læs gratis den danske manual til Emerson CK9902 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om Emerson CK9902, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

LOCATION OF CONTROLS

1. ALARM RESET Button.

2. SNOOZE/SLEEP OFF/RADIO OFF Button.

3. RADIO ON Button.

4. ALARM Button.

5. MINUTE Button.

6. CLOCK Button.

7. HOUR Button.

8. SLEEP Button.

9. DIMMER (Hi/Lo) Switch.

10. ALARM(OFF/RAD/BUZ) Switch.

11. VOLUME Control.

12. Clock Display.

13. AM/FM Band Switch.

14. Dial Scale and Pointer.

15. TUNING Control.

PREPARATION FOR USE

SURE-ALARM BATTERY BACK UP SYSTEM

This clock radio includes a battery back up system that will maintain the correct time

and alarm settings in case of a temporary power interruption. As long as the battery

has sufficient power, it will also operate the Radio or Buzzer alarm to wake you up

even if the power is ‘Off’ at your normal wake up time. The battery back up system

requires one 9 volt battery,(not included). We recommend you use an alkaline

battery for longest life.

• Open the battery compartment door, located on the back of the radio cabinet.

• Gently pull the battery terminal outside the battery compartment.

• Connect the 9 volt battery to the battery terminal. It can only be

connected one way.

• Push the battery and the terminal back into the battery

compartment.

• Replace the battery compartment door.

If the power is interrupted the clock display goes ‘Off ’. However the clock will

continue to run, powered by the 9 volt battery. When power is restored the clock will

come ‘On ’ again to the correct time. The alarm setting will also be maintained.

NOTE: If no battery is installed, or if the battery is exhausted and power is

interrupted, the time and alarm settings will be lost. When power is restored the clock

display will begin flashing “12:00 AM”. This is your indication that the time is

incorrect and needs to be reset. Don’t forget to reset both the time and the wake up

time.

A fresh alkaline battery should be able to provide back up power for up to a year in

normal circumstances. However if you live in an area that has frequent power

interruptions the battery life will be reduced. For best results you should install a new

battery every 8 to 12 months. If you installed a battery but you notice that the display

is flashing, your battery is exhausted and should be replaced.

POWER SOURCE

This radio operates on 120V, 60Hz AC house

current only. Unwind the AC power cord and

connect the plug to any conveniently located AC

outlet.

AM/FM Clock Radio with 0.9” Display

MODEL : CK9902

7 6 5

NOTES:

1.) This radio uses a polarized AC plug which has one blade wider than the other.

This plug will only fit into a polarized AC outlet. This is a safety feature. If the

plug will not fit, you may have an older non-polarized AC outlet. Do not defeat

the safety feature by trying to file the wider blade, or replacing the plug. Contact

an electrician to replace your outdated outlet.

2.) Do not connect this unit to an AC outlet which is controlled by a wall switch. The

AC outlet should be ‘live’ at all times.

ANTENNA INFORMATION

FM - The FM antenna is built into the AC power cord. Be sure the AC power cord

is fully unwound and extended to its full length for best FM reception.

AM - The AM ferrite bar antenna is inside the radio cabinet. If AM reception is noisy

or weak, try turning the radio slightly until the bar antenna is pointing towards

the transmitter. Experiment until you find the position which provides the

clearest reception.

SETTING THE TIME

• Press and hold the CLOCK and HOUR buttons to advance the display to the

correct hour.

• Press and hold the CLOCK and MINUTE buttons to advance the display to the

correct minute.

NOTE: If the AM Indicator in the upper left corner of the display is ‘On’, the time

displayed is “AM”. If the AM Indicator does not appear in the display, the

time displayed is “PM”. Be sure to set the time correctly for AM or PM.

LISTENING TO THE RADIO

• Press the RADIO ON button.

• Slide the BAND selector to the desired position - AM or FM.

• Select the desired station with the TUNING control.

• Adjust the VOLUME control to the desired level.

• Press the SNOOZE/SLEEP OFF/RADIO OFF button to shut the radio ‘Off’.

SETTING THE WAKE-UP TIME

• Press and hold the ALARM and HOUR buttons to set the desired wake-up hour.

• Press and hold the ALARM and MINUTE buttons to set the desired wake-up

minute.

NOTE: If the AM Indicator in the upper left corner of the display is ‘On’, the wake-

up time displayed is “AM”. If the AM Indicator does not appear in the display,

the wake-up time displayed is “PM”. Be sure to set the wake-up time

correctly for AM or PM.

WAKE TO RADIO

Set the wake-up time as indicated above. Also tune the radio to the band and station

that you want to hear at the wake up time, adjust the volume if necessary, and shut

the radio ‘Off’.

• Slide the ALARM selector to the RAD (Radio) position.

• At the selected wake-up time the radio will begin to play. It will continue for

1 hour and 59 minutes and then shut off automatically and reset itself for the

following day.

• To stop the radio sooner, press the ALARM RESET button. The radio stops

immediately and resets itself for the following day.

• To cancel the wake to radio function slide the ALARM selector to the ‘Off’

position.

WAKE TO BUZZER ALARM

Set the wake up time as indicated above.

• Slide the ALARM selector to the BUZ (Buzzer) position.

• At the selected wake up time the buzzer tone will come on. It will continue for 1

hour and 59 minutes and then shut off automatically and reset itself for the

following day.

• To stop the buzzer sooner, press the ALARM RESET button. The buzzer stops

immediately and resets itself for the following day.

• To cancel the wake to buzzer function slide the ALARM selector to the ‘Off’

position.

SNOOZE / REPEAT ALARM

If you need a few extra minutes sleep after the alarm comes on, press the SNOOZE

button once.The radio or buzzer alarm stops for 9 minutes and then turns on again.

This procedure can be repeated many times if necessary. Each time the SNOOZE

button is pressed the alarm shuts off for 9 minutes and then comes on again.

NOTE: The Snooze / Repeat Alarm operation will function for up to 1 hour and 59

minutes after the alarm comes on. After 1 hour and 59 minutes the alarm

no longer repeats.

OPERATING INSTRUCTIONS

CLOCK DISPLAY

AM Indicator

ALARM Indicator

Visit our web site at “www.emersonradio.com”

Produkt Specifikationer

Mærke:	Emerson
Kategori:	Ikke kategoriseret
Model:	CK9902

Har du brug for hjælp?

Hvis du har brug for hjælp til Emerson CK9902 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Emerson Manualer

Emerson CKS1855 Manual

20 September 2025

Emerson MW1101W Manual

19 September 2025

Emerson SR5999 Manual

19 September 2025

Emerson MW8106W Manual

19 September 2025

Emerson BAR800 Manual

19 September 2025

Emerson PD3500RD Manual

18 September 2025

Emerson CR519B Manual

18 September 2025

Emerson SCR120 Manual

18 September 2025

Emerson CKS1702 Manual

18 September 2025

Emerson MW8773SL Manual

18 September 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Metra 95-8275 Manual

30 Oktober 2025

Philips Evnia34M2C5500Q Manual

30 Oktober 2025

Wimberley AP-611 Manual

30 Oktober 2025

DeWalt DCS374 Manual

30 Oktober 2025

Tronic TLG 400 B2 Manual

30 Oktober 2025

Abus JC2208 Manual

30 Oktober 2025

Abus HYP-E Manual

30 Oktober 2025

Iogear GearPower 145W GPAWC145W Manual

30 Oktober 2025

DAP-Audio ZA-9250DAB Manual

30 Oktober 2025

Abus E222 Manual

30 Oktober 2025