Eureka Copper Canyon 1610 Manual

Eureka Fuld Copper Canyon 1610

Læs gratis den danske manual til Eureka Copper Canyon 1610 (2 sider) i kategorien Fuld. Denne vejledning er vurderet som hjælpsom af 57 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 29 anmeldelser. Har du et spørgsmål om Eureka Copper Canyon 1610, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

ﬁg 13

Component List: 1 Tent Body, 6 Wall Poles, 3 Roof Poles, 2 Brim Rods,

1 Fly with Guy Ropes, 1 Carry Bag, 1 Stake Bag/Stakes, 1 Pole Bag

2. Assemble the shock

corded poles and divide

according to size and shape.

Take care; make sure that

each pole section is fully

seated into the next. Do not

allow the sections to snap

together as this can damage

the ends. See ﬁg 2.

1. Remove from the carry bag and separate all the components. Unroll and unfold the

tent fabric with the top side up, on a clean, dry space and open the doors. If windy,

stake down the windward corner. This is a large tent, you will need two people for

set-up. See ﬁg 1.

4. Start on one end and insert Raise the tent.

black wall poles into the corner elbows At .

the bottom of each pole, insert the pin/ring

(attached to the corner web) into the

bottom of each pole. Repeat on the other

end. Next, install the tan poles at the

center. With the tans, it works best to insert

the ring/pin ﬁrst and then ﬁt the pole into

the elbo See ﬁg 6, 7 & 8. w.

Repeat on the other side until the tent is at

full height and freestanding.

5. to the wall poles. See ﬁg 9.Attach all clips

6. through the web loops. Stake the tent down

Stake opposite corners while applying tension to

smooth the ﬂoor wrinkles. Next, align the center

poles and stake down. Do this before you add the

ﬂy. See ﬁg 10 & 11.

Take Down: Pull up all stakes. Release the ﬂy’s hook & loop straps and J-hooks.

Remove ﬂy. Remove clips from wall poles and pull poles off of the pins.

Remove roof poles. Collapse all poles and sto Fold the tent onto itself then w.

fold the ﬂy and lay it on tent. Roll up both towards an open door and stow.

Options: Floor Saver- med. square, Gear Lofts- A & F, and a 120v Rope Light

7. Attach the ﬂy to the tent. Turn the ﬂy right side up and orient

it along the length of the tent. Grasp two corners of the of the

ﬂy and drag them up and over the roof to completely cover the

tent. (This is much easier with two people.) The brim rod

sleeves should hang out over the tent ends At the wall poles, .

reach under the ﬂy and attach the hook & loop straps to the

poles just below the elbow and down the length of the poles,

securing the ﬂy in place. See ﬁg 12.

8. At Attach the brim rods.

one end of the tent, reach

under the ﬂy and slide an

assembled brim rod

through the sleeve. See ﬁg

13. Locate the grommets at

the corner of the tent and

insert the tips of the brim

rods into these grommets.

Repeat at other end. See

ﬁg 14.

Assembly Instructions for

Copper Canyon 1610

ﬁg 2

ﬁg 1

ﬁg 3

ﬁg 5

ﬁg 6

ﬁg 11

ﬁg 12

ﬁg 15

ﬁg 14

ﬁg 16

ﬁg 17

ﬁg 7ﬁg 8

ﬁg 9

ﬁg 10

3. Insert the roof poles. Slide both black roof poles into their sleeves sewn on the tent

body. They should run from corner to corner crossing in the center. The sleeves are color

coded with black trim. Fit one end of each into a nylon elbow attached to the roof corners

at and . Move to the opposite side, arch the poles and again ﬁt into the nylon elbows A B

at and . Insert the gray roof pole, front to backC D , into the remaining sleeves and over

the two black poles. Fit the gray poles into the elbows at and . See ﬁg 3, 4 & 5.E F

REV B 4.09.

NOTE: One arm of

each center elbow

has interior ribs.

The gray roof poles

insert into the

ribbed arms Wall .

poles insert into

the plain arms.

ﬁg 4

9. from the ﬂy to the nylon Attach the shock corded J-hooks

rings on the webs at the bottom of the poles. See ﬁg 15.

10. Guy out the tent.

This tent has very large straight walls that

act differently in high winds There are pre-attached guy out .

ropes in the pockets on the ﬂy at the top of each pole. Stake

out the ropes and adjust tension with the sliders Additional guy .

out instructions on the back side of this sheet. See ﬁg 16.

11 Tent door has “Sweep Out” feature. Stake the web loop .

(inside the door) to the ground to easily whisk dirt out of the

tent. See fig 17.

Brim Rods

Center

Wall poles

Corner

Wall poles

Roof poles

Produkt Specifikationer

Mærke:	Eureka
Kategori:	Fuld
Model:	Copper Canyon 1610

Har du brug for hjælp?

Hvis du har brug for hjælp til Eureka Copper Canyon 1610 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Fuld Eureka Manualer

Eureka Juno 3XTA Manual

21 Maj 2024

Eureka Headquarters Manual

5 April 2024

Eureka Midori 4 Manual

30 Marts 2024

Eureka Midori 2 Manual

20 Marts 2024

Eureka Grayback Manual

16 Marts 2024

Eureka Tetragon Manual

21 Februar 2024

Eureka Taron 2 Manual

19 Januar 2024

Eureka Jade Canyon 6 Manual

9 December 2023

Eureka Copper Canyon 1610 Manual

23 November 2023

Eureka K2-XT Manual

7 November 2023

Fuld Manualer

Nyeste Fuld Manualer

Deryan 4P Pop-Up Tent Manual

11 December 2025

Deryan Dome 2P XL Tent Manual

10 December 2025

Vevor 120813 Manual

2 December 2025

Vevor ORGTK8080180 Manual

30 November 2025

Vevor ORGTK100100200 Manual

30 November 2025

Vevor CPT3W1D Manual

23 November 2025

Vevor AUTO4ALU Manual

23 November 2025

Vevor INDIAN4W Manual

22 November 2025

Vevor 120904 Manual

21 November 2025

Vevor 120838 Manual

20 November 2025