Eureka N!ergy 1210 Manual

Eureka Fuld N!ergy 1210

Læs gratis den danske manual til Eureka N!ergy 1210 (3 sider) i kategorien Fuld. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om Eureka N!ergy 1210, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/3
Assembly Instructions
for the N!ergy 1210 Tent
A
B
A
BD
Cfig 1
tent poles
fly poles
fig 8
fig 2
fig 5
Component List:
1 Tent 2 Tent Poles 1 Carry Bag
1 Stake Bag W/Stakes 1 Rain Fly
2 Fly Poles 1 Pole Bag 6 Pull Out Cords
1 Gear Loft 1 Divider
1. on the ground. Separate the rest of the Unroll and unfold the tent
components and place to one side. Open the door before pitching the
tent. Do not stake the tent down (however, in windy conditions, stake
down one corner that faces into the wind).
2. Keep the end sections from Assemble all of the shockcorded poles.
snapping together, as this can damage the ends. Make certain each
plain end has been properly seated into the metal ferrule.
3. Insert an assembled pole
through both sleeves from to A
B. Insert the second pole through
the sleeves from to , forming C D
an X across the tent. See fig 1.
There is a fabric loop at the tent’s
peak. Capture this loop with the
top pole as you move through
the sleeves. See fig 1 & 2.
4. At A, insert the web corner pin into the end of the
tent pole ferrule At B, grasp the tent corner pin in one .
hand, the tent pole in the other. Arch the pole and
place the pin into the end of the pole. See Fig 3 & 4.
Repeat this with the second pole from C to D raising the
tent as you go. See fig 5.
5. to Start at the bottom and attach all the clips
the poles to create a freestanding tent. Place it in
the desired location. See fig 6.
6. through the Stake the tent down
corner loops. Stake the opposite corners
while applying tension to smooth the
floor wrinkles.
Also, stake out the beckett
beneath each of the side windows.
See
fig 7 & 8.
7. Lay out the fly with the inside side up, on ground at the front of Attach the fly to the poles.
the tent. Fit the fly poles into the pockets sewn to the hem The poles run from side to side .
down the center of the fly forming an X. Secure the fly to the poles by wrapping the hook &
loop fastener around the fly poles. See fig 9, 10 and 11.
8.
Attach the fly to the tent
. Turn the fly assembly over and align it so
that the poles point out over the doors. Grasp the corners of the of the
fly and drag them up and over the roof to completely cover the tent.
(This is much easier with two people)
At the corners of the tent, reach under the fly and attach the hook & loop
straps to the tent poles, securing the fly in place. See fig 12.
At the bottom/corners of the tent, attach the shockcorded J-hooks to the
rings on the corner webs. See fig 13.
9.
Tie a guy rope
to each of the 4
rings attached to the fly and stake
out Adjust tension with the in-line .
sliders. See fig 14 & 15.
YOUR TENT IS READY !
fig 4
fig 9
fig 10
fig 11
fig 7
fig 6
fig 12 fig 13
fig 15
fig 14
REV D 4.09
NOTE:
• Although it is possible to pitch this tent alone, it is faster/easier with two
people.
• Do not drop tent bag or pole bag on its end. Do not bounce tent bag on
its end to get the tent out These actions may cut the shockcord and/or .
damage the pole ends.
• The N!ergy series tents are pre-wired with three 12V outlets Take care .
to keep them in their sleeves and avoid stepping on the sockets and
wires during assembly.
fig 17
green
blue
fig 16
E! Power System: To use, you will need a power source. Our E! Power Pak™ is sold separately. Once connected to
power, the control will display “green” at any switch that is “ON” and the “ON” socket will glow blue. See fig 16.
E! Power Port: Open zipper and run extension cord through opening.
Close zipper so that it rests next to the extension cord. Make sure the
zipper cover is not twisted or tucked The cover must lay flat against .
the outside of the tent to keep out rain.
Accessories: E! Power Fan/Light, E! Power Reading Light and an E!
Power 12v Adapter Cord.
Sweep Out: Inside, at the bottom of the door is a sewn-in web loop. Pull
this loop to the outside and stake it down to provide a ready exit for
floor sweepings. See fig 17.
Take Down: Pull up all stakes. Release the fly’s hook & loop straps. Remove fly.
Remove fly poles. Remove clips from tent poles and pull poles off of the pins.
Collapse all poles and sto Fold the tent onto itself then fold the fly and lay it w.
on tent. Roll up both towards the open door and stow.
Read the important safety instructions on the reverse side.
fig 3

Produkt Specifikationer

Mærke: Eureka
Kategori: Fuld
Model: N!ergy 1210

Har du brug for hjælp?

Hvis du har brug for hjælp til Eureka N!ergy 1210 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Fuld Eureka Manualer

Eureka

Eureka Juno 3XTA Manual

21 Maj 2024
Eureka

Eureka Headquarters Manual

5 April 2024
Eureka

Eureka Midori 4 Manual

30 Marts 2024
Eureka

Eureka Midori 2 Manual

20 Marts 2024
Eureka

Eureka Grayback Manual

16 Marts 2024
Eureka

Eureka Tetragon Manual

21 Februar 2024
Eureka

Eureka Taron 2 Manual

19 Januar 2024
Eureka

Eureka Jade Canyon 6 Manual

9 December 2023
Eureka

Eureka Copper Canyon 1610 Manual

23 November 2023
Eureka

Eureka K2-XT Manual

7 November 2023

Fuld Manualer

Nyeste Fuld Manualer

Outwell

Outwell Stonehill 7 Air Manual

10 August 2025
Outwell

Outwell Moonhill 6 Air Manual

9 August 2025
Outwell

Outwell Sunhill 3 Air Manual

9 August 2025
Outwell

Outwell Lounge L Annexe Manual

9 August 2025
Outwell

Outwell Backroads Awning Room Manual

23 Juli 2025
Outwell

Outwell Nashville 5 Air TC Manual

23 Juli 2025
Outwell

Outwell Tennessee 5 Air Manual

23 Juli 2025
Outwell

Outwell Fresno Manual

23 Juli 2025
Outwell

Outwell Florida 6 Air Manual

23 Juli 2025
Outwell

Outwell Monterey 4 Air Manual

23 Juli 2025