EXSYS EX-1315IS Manual

EXSYS Andet computertilbehør EX-1315IS

Læs gratis den danske manual til EXSYS EX-1315IS (2 sider) i kategorien Andet computertilbehør. Denne vejledning er vurderet som hjælpsom af 11 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 6 anmeldelser. Har du et spørgsmål om EXSYS EX-1315IS, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Die EX-1315IS USB 3.2 Gen 1 Dockingstation stellt einen seriellen RS232 Port mit

Überspannungsschutz und Isolation, einen Port mit Ethernet 10/100/1000Mbps sowie zwei USB

3.2 Gen 1 Ports zur Verfügung. Durch die einfache Installation muss der Rechner nicht geöffnet

werden und die EX-1315IS kann bei laufendem Betrieb installiert werden.

Kompatibilität: USB 1.1, 2.0, 3.0, 3.1, 3.2 / TCP/IP 10/100/1000

Betriebssysteme: Win 9.x/ME/2000/XP/Vista/7/8.x/10/11/Server 20xx/Linux/MAC

Anschlüsse: 1x USB 3.0 B-Buchse, 2x USB 3.0 A-Buchse, 1x 9 Pin D-SUB Stecker,

1x RJ45 Ethernet Anschluss, 1x T-Block 7-48V, 1x 12V/3A Buchse

Lieferumfang: EX-1315IS, USB-Kabel, DIN-Rail Kit, Netzteil 12V/3A, Anleitung

BESCHREIBUNG & TECHNISCHE DATEN

AUFBAU

CONNECTORS

CLEANING

DRIVER INSTALLATION

Serial RS-232

After the hardware installation Windows will recognize the device automatically and install the

drivers. If the driver should not be installed automatically, please download the driver from our

homepage (www.exsys.de / www.exsys.ch) first. Now select the folder with your operating

system and install the driver. Follow the hardware assistant and finish the installation.

Important! Restart your PC in any case after installing the drivers.

CHECK INSTALLED DRIVER

Open the >Device manager<. Now you should see at „Ports (COM & LPT)“ and „USB-

Controller“ the following new entry:

If you see this or a similar information the device is installed correctly.

To clean the unit, use only a dry, lint-free cloth and apply light pressure to remove dirt. Be

careful not to leave any fibres of the cloth in the connector area.

Never use a damp or wet cloth for cleaning!

Switzerland:

EXSYS Vertriebs GmbH

Dübendorfstrasse 17

8602 Wangen

www.exsys.ch

Germany:

EXSYS Vertriebs GmbH

Industriestrasse 8

61449 Steinbach

www.exsys.de

Italy:

EXSYS Italia Srl

Via Belvedere, 45/B

I-22100 Como

www.exsys.it

Anleitung

Vers. 1.0, 21.12.22

Anleitung

Vers. 1.1 / 22.08.24

EX-1315IS

ANSCHLÜSSE

HARDWARE INSTALLATION

Because there are large differences between PC’s, we can give you only a general installation

guide for the EX-1315IS. Please refer your computers reference manual whenever in doubt.

1. Connect the EX-1315IS USB to the USB A-Port at the your PC.

2. When you are ready you can start your PC and continue with the Driver Installation.

USB 3.0 B-Buchse

Betriebs LED

9 Pin Seriell RS-232 Stecker

RJ45 Anschluss mit Status LED´s

2 x USB 3.0 A-Buchse

12V/3A DC Buchse

Terminal Block +7V~+48V

Achtung!

Stecker niemals umgekehrt

oder mit Gewalt einstecken.

D-

GND

StdB_SSTX -

StdB_SSTX +

GND_DRAIN

StdB_SSTX+

StdB_SSTX -

D+

VBus

StdB_SSTX -

StdB_SSTX+

GND_DRAIN

VCC

StdB_SSTX +

StdB_SSTX -

D+ D-

GND

USB 3.2 B-Buchse:

Attention!

Never plug in with force

or in wrong direction.

USB 3.2 A-Port:

RS-232 Connector:

Serial 9 Pin D-SUB Connector

Pin Signal Pin Signal Pin Signal

1 CDC 4 DTR 7 RTS

2 RXD 5 GROUND 8 CTS

3 TXD 6 DSR 9 RI

RJ45 Connector:

RJ45 Connector

Pin Signal Pin Signal Pin Signal

1 BI_DA+ 4 BI_DC+ 7 BI_DD+

2 BI_DA- 5 BI_DC- 8 BI_DD-

3 BI_DB+ 6 BI_DB-

+7V ~ 24V T-Block:

+7V ~ 24V

GND (Ground)

ATTENTION!!!

Never connect power to GND it will destroy your Hardware!

ATTENTION!!!

Use only with included power supply!

12 Volt Connector:

Ehernet LAN

After the hardware installation Windows will recognize the device automatically and install the

drivers. If the driver should not be installed automatically, please download the driver from our

homepage (www.exsys.de / www.exsys.ch) first. Now select the folder with your operating

system and install the driver. Follow the hardware assistant and finish the installation.

Important! Restart your PC in any case after installing the drivers.

CHECK INSTALLED DRIVER

Open the >Device manager<. Now you should see at „Ethernet Adapter“ the following new

entry:

If you see this or a similar information the device is installed correctly.

USB 3.2

After the hardware installation, the OS will recognize the device automatically and install the

drivers

CHECK INSTALLED DRIVER

Open the >Device manager<. Now you should see at „USB Devices“ the following new entry:

<Generic USB Hub>.

Produkt Specifikationer

Mærke:	EXSYS
Kategori:	Andet computertilbehør
Model:	EX-1315IS
Bredde:	150 mm
Dybde:	61 mm
Højde:	25 mm
Vægt:	400 g
Produktfarve:	Hvid
Opbevaringstemperatur (T-T):	-40 - 75 °C
Relativ luftfugtighed ved drift (H-H):	5 - 95 %
Ethernet LAN-porte (RJ-45):	1
Antal USB 3.2 Gen 1 (3.1 Gen 1) type-A-porte:	2
Ethernet LAN:	Ja
Driftstemperatur (T-T):	0 - 55 °C
Ethernet LAN-datahastigheder:	10,100,1000 Mbit/s
Certificering:	CE, FCC
Netværksstandarder:	IEEE 802.3, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3u
DC-in-stik:	Ja
Strømkilde type:	DC
Bæredygtighedscertifikater:	RoHS
USB-stik type:	USB Type-A, USB Type-B
Antal serielle porte:	1
Wake-on-LAN klar:	Ja