Extron DVI 104 Manual

Extron AV forlænger DVI 104

Læs gratis den danske manual til Extron DVI 104 (5 sider) i kategorien AV forlænger. Denne vejledning er vurderet som hjælpsom af 25 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 13 anmeldelser. Har du et spørgsmål om Extron DVI 104, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

DVI 104 TX/RX • User Guide

The Extron DVI 104 Tx and DVI 104 Rx are ﬁber optic transmitter and receiver units that extend DVI signals up to 500 meters

(1,640 feet) using four multimode ﬁber optic cables. Optional four-ﬁber multimode cables are available in varying lengths.

• The transmitter plugs directly into the source device and the receiver plugs directly into the display device.

• The transmitter and receiver pair can handle DVI video signals with resolutions up to 1920 x 1200 or 1080p at 60 Hz.

FCC Class A Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part15 of the FCC

rules. The ClassA limits provide reasonable protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is

likely to cause interference. This interference must be corrected at the expense of the user.

NOTE: This unit was tested with shielded I/O cables on the peripheral devices. Shielded cables must be used to ensure

compliance with FCC emissions limits.

For more information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see

the “ ” on the Extron website.

Extron Safety and Regulatory Compliance Guide

FDA/IEC 60825-1 Requirements

CLASS 1 LASER PRODUCT

Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice No. 5, dated June 24,

2007.

The product is intended to be used with the ﬁber optic cables fully installed.

This product meets the applicable requirements of IEC 60825-1, Edition 1 (2007).

Any service to this product must be carried out by Extron Electronics and its qualiﬁed service personnel.

Application Diagram

PC with DVI Output

DVI 104

Transmitter

DVI 104

Receiver

Hi-resolution

Flat Panel Display

with DVI-D Input

4 Multi Mode

Fiber

Up to 500 meters (1640 feet)

DVI 104 TX/RX • User Guide

Features

Power supply — Separate power supplies are provided for both the transmitter and receiver.

Power LEDs — The LEDs are on the top and bottom panels of both the receiver and transmitter. They illuminate green when the unit

is receiving power.

No mounting hardware required — The units plug directly into the source device (transmitter) or output device (receiver) and take up

very little space.

EDID Minder — The DVI 104 transmitter is able to capture and store the resolution and refresh rate of the display device, which

ensures that the source boots up with the correct resolution.

Long cable runs — The DVI 104 Tx/Rx uses four ﬁber optic cables to extend video signals up to 500 meters (1,640 feet). The cables

must be either 62.5/125 multimode cable or 50/125 multimode cable.

High resolution signal transmission — The units transmit signals at resolutions up to 1920 x 1200 or 1080p @ 60 Hz.

High rate of data transfer — The units can transmit signals at up to 1.65 Gbps

Front Panel Features

1 2 a — The transmitter and receiver both have plugs for a 3.5 mm jack to provide Power input

5 VDC to the unit.

The center pin of the jack carries +5 VDC; the outer shell of the jack is the negative rail.

NOTES:

• If the source device is able to provide 5 VDC on pin 14 of its DVI output, the

transmitter can draw power from the source device. If the source is a laptop or a

PC using a PCI-E graphics card, it will not be able to provide enough power and the

transmitter must be powered with a separate external power supply.

• The receiver must be powered by an external power supply through the power

input plug.

b — Four ﬁber optic cables connect the transmitter to the receiver. The cables connect to the four female LC jacks in each LC jacks

of the units.

A label on the top panel identiﬁes the unit as the transmitter or receiver and identiﬁes the ﬁber optic port numbers and the power

input.

NOTES:

• For the transmitter, port 1 is closest to the power input and port 4 is furthest away. For the receiver, port 4 is closest to

the power input and port 1 is furthest away.

• Although the orientation is reversed, ports with the same number must be connected by the same cable, so that port 1

on the receiver is connected to port 1 on the transmitter, and so forth.

Insert the end of the ﬁber optic cable into the appropriate plug on the transmitter

Normal Position

Adjusted Position

Locking catch

Release catch

or receiver. The locking catch should snap into the slot and hold the cable securely

in place.

If the cable is loose or slips out of the slot easily, move the release catch from its

normal position above the locking catch, to the adjusted position under the locking

catch (see the ﬁgure above right). This provides the extra leverage required to keep

the locking catch in place and hold the cable securely.

Produkt Specifikationer

Mærke:	Extron
Kategori:	AV forlænger
Model:	DVI 104

Har du brug for hjælp?

Hvis du har brug for hjælp til Extron DVI 104 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

AV forlænger Extron Manualer

Extron DTP3 T 311 Manual

28 Oktober 2024

Extron DTP3 R 311 Manual

27 Oktober 2024

Extron DVI 104 Manual

14 September 2024

Extron PowerCage FOX Tx DVI Plus Manual

11 September 2024

Extron DDX 102 Manual

11 September 2024

Extron eLink 100 Manual

6 September 2024

Extron FOX Rx AV SM Manual

5 September 2024

Extron MDA 4V EQ Manual

5 September 2024

Extron SVEQ 100 Manual

5 September 2024

Extron XTP FR HD 4K MM Manual

5 September 2024

AV forlænger Manualer

Nyeste AV forlænger Manualer

Genexis Elite HX30 Manual

8 Juni 2025

Genexis Elite HX40 Manual

8 Juni 2025

Provision-ISR PR-HDoNet+ Manual

8 April 2025

Apantac DP-FIB-II Manual

25 Februar 2025

Adder Link X-DVI PRO-DL Manual

28 Januar 2025

Adder Link X100 Manual

28 Januar 2025

Kramer EXT3-U3-T Manual

20 Januar 2025

Kopul XLR4F-RJ45 Manual

14 Januar 2025

Kopul RM-4X4XMFRJ45 Manual

13 Januar 2025

Planet VF-106G-KIT Manual

13 Januar 2025