Federal Signal PMXC-SB Manual


Læs gratis den danske manual til Federal Signal PMXC-SB (16 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 49 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 25 anmeldelser. Har du et spørgsmål om Federal Signal PMXC-SB, eller vil du spørge andre brugere om produktet?

Side 1/16
MODÈLE 121X
INSTRUCTIONS D’INSTALLATION ET DE SERVICE POUR LE
MODÈLE 121X SÉRIE C DE LAMPE ANTI-EXPLOSION 120VCA ET 24VCC
MODELO 121X
INSTRUCCIONES DE INSTALACION Y SERVICIO PARA LUZ A
PRUEBA DE EXPLOSION DE 120VCA Y 24VCC MODELO 121X SERIE C
MODEL 121X
INSTALLATION AND SERVICE INSTRUCTIONS FOR MODEL 121X
SERIES C 120 Vac AND 24 Vdc EXPLOSION-PROOF LIGHT
25500043
REV. A1 1014
Printed in U.S.A.
-1-
INSTALLATION AND SERVICE INSTRUCTIONS FOR FEDERAL MODEL 121X
SERIES C 120 Vac AND 24 Vdc EXPLOSION-PROOF LIGHT
SAFETY MESSAGE TO INSTALLERS
It is important to follow all instructions shipped with this product. This device is to be
installed by a trained electrician who is thoroughly familiar with the National Electri-
cal Code and will follow the NEC Guidelines as well as local codes.
The selection of the mounting location for the device, its controls and the routing of the
wiring is to be accomplished under the direction of the facilities engineer and the safety
engineer. In addition, listed below are some other important safety instructions and
precautions you should follow:
Read and understand all instructions before installing or operating this equipment.
Do not connect this light to the system when power is on.
After installation, ensure that all set screws and threaded joints are properly tight-
ened.
To prevent ignition of hazardous atmospheres, disconnect the xture from the sup-
ply circuit before opening. Keep tightly closed when in operation.
After installation, test the light system to ensure that it is operating properly.
After testing is complete, provide a copy of this instruction sheet to all personnel.
Establish a procedure to routinely check the light system for proper activation and
operation.
Failure to follow all safety precautions and instructions may result in property damage,
serious injury, or death.
I. GENERAL
The Model 121X Light is an explosion-proof visual signaling device for hazardous
locations and provides 90 ashes per minute. This light is UL listed for indoor and
outdoor use.
This equipment is suitable for use in Class I, Div. 1, Groups C and D; Class II, Div. I,
Groups E, F and G; Class III and non-hazardous locations.
These devices are intended for permanent installation and operation in accordance
with Title 46, Code of Federal Regulations, Part 183, Sub-part I, Section 183.410,
and the applicable requirements of the American Boat and Yacht Council, Inc., and/
or ANSI / NFPA 302, “Fire Protection Standard for Pleasure and Commercial Motor
Craft.
WARNING
EXPLOSION HAZARD—This light xture is not backward compatible with
older products. Do not use this light xture with the Series A versions of
model CMXC, CMXC-R, PMXC, PMXC-R, WMXC, or WMXC-R mounting acces-
sories. Failure to follow this warning may result in personal injury or death.
II. UNPACKING
WARNING
EXPLOSION HAZARD — Damaged glass domes can lead to explosions
which could result in serious injury or death. Replace damaged domes.


Produkt Specifikationer

Mærke: Federal Signal
Kategori: Ikke kategoriseret
Model: PMXC-SB

Har du brug for hjælp?

Hvis du har brug for hjælp til Federal Signal PMXC-SB stil et spørgsmål nedenfor, og andre brugere vil svare dig