1
Introduction
Information about radio frequency compliance is subject to change without notice. For up-to-date
information, go to www.flukenetworks.com or www.fluke.com.
FCC/IC Information
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his own
expense.
The term “IC” before the radio certification number only signifies the device meets Industry’s
Canada technical specifications.
Note
Changes or modifications to the wireless 2.4 GHz radio not expressly approved by Fluke
Corporation could void the user’s authority to operate the equipment.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
The radio transmitter has been approved by Industry Canada to operate only with the antenna
supplied. Use of any other antenna is strictly prohibited for use with this product.
L'émetteur radio a été approuvé par Industrie Canada pour fonctionner uniquement avec
l'antenne fournie. L'utilisation de toute autre antenne est strictement interdit d'utiliser ce produit.
MPE/SAR/RF Exposure Information
This device was verified for RF exposure and found to comply with FCC OET-65 RF Exposure
and RSS-102 requirements. This Product meets the SAR exemption based on its output power.
