Friedland D417E - Evo 50m Manual

Friedland Dørklokke D417E - Evo 50m

Læs gratis den danske manual til Friedland D417E - Evo 50m (1 sider) i kategorien Dørklokke. Denne vejledning er vurderet som hjælpsom af 42 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 21.5 anmeldelser. Har du et spørgsmål om Friedland D417E - Evo 50m, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

D417E

Fig 6

1. Open the bell push

To open the front cover carefully

insert a flat bladed screw driver, into

the slot and twist gently (A). When

refitting the front cover to ensure

the weather proofing is maintained,

always mount the bell push in the

upright position and replace the

cover securely. Fig 1

2. To fit or replace the battery

Open the front cover and insert

the CR 2032 Lithium coin cell

battery into the base as shown

in Fig 2. Any debris created

during installation must be

removed from the base before

fitting battery, to ensure good contact.

3. Mount the bell push

Ensure the wall surface is clean

and dry. Mount using either the

double sided sticky pad on a

smooth surface, or the screws

and wall plugs provided, See Fig 3.

Do not mount the push on or near

(< 30cm) large metal objects, as it

will block signals from the push.

4. Test the bell push

When the bell push button is pressed,

the confidence light (B) in Fig 4, will

illuminate to reassure the caller that

the bell push is working.

The light will flash 5 times when

the battery needs replacing.

5. Use of the door chime

Plug the chime into any

220-240V BS 1363 socket,

installed in a clean dry

environment, situated

within transmission

range of the bell push,

as shown in Fig 5.

6. Automatic Programming of bell pushes

The first time a chime unit is powered up, the sounds available

are demonstrated. Press the door push until the chime

responds with a tune. You can leave this tune or change it to a

desired tune by using button A (see fig 6) (see Sound Selection).

To programme a second push, press the push button until the

chime sounds, then use button B to change the tune if

required. Programming is now completed.

If more than 5 minutes has elapsed, you will have to reset the

chime programing by pressing and holding buttons A and B

until the chime sounds, this takes approximately 5 seconds.

The chime can then be programmed to 1 or 2 door pushes.

All EVO and Décor Chimes and Bell Pushes use a self learning

feature to ensure no interaction from other neighbouring

systems.

7. Sound Selection

A = Main push sound selection

B = Second push sound selection

Chime tune options are as follows:

1. Tone Bar 2 Note (Default Tune for 1st Push)

2. Bass clarinet (Default Tune for 2nd Push)

Fig 1

Fig 2

Fig 4

Fig 5

Fig 3

Evo 50m* Wirefree

Plug-In Chime Kit

Declaration

Novar ED&S hereby declares that this

wirefree chime kit is in compliance with

the essential requirements and other

relevant provisions of the Radio and

Telecommunications Terminal Equipment

(R & TTE) directive, 1999/5/EC

Pack contents:

50m Plug-In Chime 230v

Bell push & CR2032 Lithium coin cell battery

Adhesive pad, 2 x screws (ø3x20mm) 2 x wall plugs (ø5x25mm)

for mounting the bell push

You will require:

A small crosshead and flathead screwdriver, a ø5 masonry drill

The stated transmission range of this product is measured in

open field conditions. Walls ceilings, and metal structures will

reduce the maximum range.

Friedland guarantees this product for 3 years from date of purchase.

Proof of purchase is required, this does not affect your statutory rights.

If you require further information about our products, call the Friedland

helpline on 01268 563066.

Friedland a Novar business, Novar ED&S, The Arnold Centre,

Paycocke Road, Basildon, Essex, SS14 3EA, England

www.friedland.co.uk

Trouble Shooting

Chime not Sounding

Chime may be positioned out of range of the bell push

Move your chime closer to the bell push

A metallic object may be blocking the signal from bell push

position



Experiment with the location of the chime to see if you can

move it in a more suitable place

The battery in the bell push may need replacing

Press the bell push. If the confidence light (B) flashes 5 times

after being pushed, replace the battery.

Note: In cold conditions, poor location or environment,

operating at maximum range it is advisable to replace the

battery more frequently before the indicator light flashes

(i.e every 12 - 18 months) to maintain optimum performance

Your bell push and chime haven't been programmed

Reset the automatic programming of your chime and bell push

Instructions

– Please retain these instructions for future reference

Produkt Specifikationer

Mærke:	Friedland
Kategori:	Dørklokke
Model:	D417E - Evo 50m

Har du brug for hjælp?

Hvis du har brug for hjælp til Friedland D417E - Evo 50m stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Dørklokke Friedland Manualer

Friedland Evo D3200 Manual

30 December 2025

Friedland Evo D3120 Manual

7 December 2024

Friedland D3005S Manual

10 September 2024

Friedland Evo Wirefree 200m - D412 Manual

21 August 2024

Friedland L430N Spectra Plus Manual

21 August 2024

Friedland Evo 100m - D421E Manual

18 August 2024

Friedland D962S Manual

8 August 2024

Friedland EvoHome and Garden Kit - D426E Manual

8 August 2024

Friedland D3200 Manual

7 August 2024

Friedland D359 Manual

6 August 2024

Dørklokke Manualer

Nyeste Dørklokke Manualer

Cata THALASSA EVO 700 GWH Manual

13 August 2025

ORNO OR-DB-RG-179 Manual

13 August 2025

Cata S PRO 6000 X Manual

13 August 2025

Cata S PRO 7000 BK Manual

13 August 2025

Cata LFK 6000 WH Manual

13 August 2025

Cata THALASSA EVO 600 GWH Manual

12 August 2025

Honeywell RCA2210N Manual

12 August 2025

Honeywell RPWL3045A Manual

12 August 2025

Honeywell RCWL3501A Manual

12 August 2025

Honeywell RCA2205N Manual

12 August 2025