181XLDC14 - ¼", 181XLDC38 - ⅜", 181XLDC12 - ½", 181XLDC1 - 1"
Please read and comply with the instructions listed on this
document. To get the best service life and performance from your
machine, clean it thoroughly before and after use by following the
instructions listed below. Minimize the use of alkaline cleaners as
they may dull the finish and cause pitting.
Be careful when handling and operating the machine, as
the blades are very sharp. Always keep your hands away
1. Place the unit on a sturdy work surface.
2. Core, slice, or cut the produce to prepare it for
3. Lift the handle and place the produce on the blades.
4. Remove hands from the cutting area.
5.Inoneuidmotion,bringthepushblockdowntoforce
the produce through the blades.
6. Lift push block and repeat as needed.
7. Clean the machine after chopping is complete using
the cleaning instructions below.
8. Do not chop produce larger than the opening in the
Note: to cut ¼" and ½", use ¼" push block. To cut ⅜", use
the push block. To cut 1 , use the 1⅜" " " push block.
1. Remove the handle, push block guide, bumpers, and
bladeandholderassemblyotheguiderods.
2. Wash the push block guide, push block, blade and
holder assembly, and frame thoroughly.
a. The push block can be removed from the push block
guide by removing the thumbscrews.
3. To disassemble the blade and holder assembly for
a. Remove the screws and the blade holder plate.
b. Gently tap the blades and the blade spacers from
a. Place the blade holder on a sturdy surface with the
blade spacer pockets facing upward.
b. Insert the 4 blade spacers with their slots toward the
inner opening of the blade holder.
c. Insert blades with the sharp edge downward and
d. Insert blades with sharp edge and slots downward.
e. Reposition the blade holder plate and secure it
f. Reposition the blade and holder assembly, bumpers,
push block, push block guide, and handle on
5. When needed, lubricate the guide rods with mineral oil,
foodgradegreaseorparan.Do not use cooking oil.
These parts can be purchased from the same location as the dicer.
181BAXL14 1/4" Blade Assembly
181BAXL38 3/8" Blade Assembly
181BAXL12 1/2" Blade Assembly
181BAXL1 1" Blade Assembly
181BL14XL 1/4" Blade (26 Blades)
181BL38XL 3/8" Blade (18 Blades)
181BL12XL 1/2" Blade (12 Blades)
181BL1XL 1" Blade (6 Blades)
181PBXL38 Pusher Block for 3/8"
181PBXL1412 Pusher Block for 1/4" & 1/2"
181PBXL1 Pusher Block for 1"
