When using electrical appliances, basic safety precauons should always be followed including the following:
• Check to make sure your home or business voltage conforms to the rated voltage of the appliance.
• Always place the appliance on a table or sturdy surface.
• Store the appliance out of reach of children to avoid any potenal accidents.
• Store the appliance in a dry space away from any humidity.
• Clean the appliance aer each use.
• DO NOT sharpen any blades that do not t within the appliance in order to avoid damage to the appliance
• DO NOT aempt to sharpen knives coated in food, fat, cooking oils, or residues. Knives must be clean and
• DO NOT leave the appliance running unaended.
• DO NOT place the appliance in water or any other liquid.
• DO NOT use harsh cleaners or scrubbing pads when cleaning the surface of the appliance.
• DO NOT allow the power cord to hang over any hot surfaces.
• use the appliance if the power cord or any part has been damaged. Damages should be xed by a DO NOT
technician in order to avoid potenal accidents.
• DO NOT use the appliance for anything outside of its intended purpose. Doing so will void the warranty.
• use any lubricants with this appliance.DO NOT
Geng to Know Your Garde 2 Stage Knife Sharpener
The Garde 2 stage knife sharpener is perfectly designed to sharpen a variety of knives with straight and serrated
edges. The 2 stage sharpening system begins with a precision sharpening stage, equipped with 100% diamond
abrasive discs to create the ideal bevel and burr. Aer only a few strokes, your knife is ready for the second stage of
sharpening called the stropping stage. In the stropping stage, exible resin sharpening disks straighten and polish
your knife’s blade, removing the burr created in the coarse grinding stage. Combined, the 2 stages result in an ex-
tremely sharp edge that is ready to withstand the rigors of your busy kitchen.
Operaon – Sharpening Serrated Knives
1. Place the end of the serrated knife in either one of the blade modules in the second stage, labeled “Polish”.
Slowly pull the blade down and through the Stage 2 blade guides. Then place your blade on the opposite side of
the Stage 2 blade module and slowly pull down and through.
2. Alternate sides in Stage 2 unl you have completed 3-4 pairs of alternang pulls.
3. Repeat steps 1-2 as necessary to achieve desired sharpness.
