Geovision GV-COM V3 Manual


Læs gratis den danske manual til Geovision GV-COM V3 (3 sider) i kategorien Kabler til pc'er og periferiudstyr. Denne vejledning er vurderet som hjælpsom af 43 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 22 anmeldelser. Har du et spørgsmål om Geovision GV-COM V3, eller vil du spørge andre brugere om produktet?

Side 1/3
GV-COM V3
The GV-COM V3 adds one RS-485 port to your computer through a USB connector. The
GV-COM V3 can convert the standard RS-232 signal, through USB connector, to RS-485
2-wire control for PTZ cameras, GV-Data Capture Box or any other RS-485 devices.
Packing List
1. GV-COM V3 x 1
2. USB Extension Cable x 1
(1.8 meters / 5.91 feet)
3. Software Disk x 1
4. Installation Guide p1-x1
Overview
RS-485
April 21, 2015 1
Installing Drivers
When you connect GV-COM V3 to the computer, the Found New Hardware Wizard will
automatically detect the device. To install the drive, follow the steps to install the drivers.
1. Insert the Software Disk. It will run automatically and pop up a window.
2. Click Install GeoVision USB Devices Driver. This dialog box appears.
3. Click Install to install the drivers. When the installation is complete, this message will
appear: Install Successfully.
4. Click Exit to close the dialog box and restart the PC.
To verify the drivers are installed correctly, go to Device Manager and expand the Ports
field. You should see one entry for XR21B1411 USB UART.
April 21, 2015 2


Produkt Specifikationer

Mærke: Geovision
Kategori: Kabler til pc'er og periferiudstyr
Model: GV-COM V3

Har du brug for hjælp?

Hvis du har brug for hjælp til Geovision GV-COM V3 stil et spørgsmål nedenfor, og andre brugere vil svare dig