GETT CK4W Manual

GETT Tastatur CK4W

Læs gratis den danske manual til GETT CK4W (39 sider) i kategorien Tastatur. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 8 anmeldelser. Har du et spørgsmål om GETT CK4W, eller vil du spørge andre brugere om produktet?

Side 1/39
www.gett-group.com
www.washable-keyboards.com
User Manual
Bedienungsanleitung
Manuel de l‘utilisateur
CK4 + CK4W Keyboard
CK4 + CK4W Tastatur
Clavier CK4 + CK4W
Supplement to the user manual CK4W EN
www.gett-group.com | www.gett.de
Putting the CK4 into service (wired version)
Connect the keyboard’s USB cable to a free USB port on your computer. The initialization procedure is taking
place when the LED lights ash on the status bar. This procedure may take a few seconds; the time required
depends on the system that you are using. The driver initialization is conrmed by the operating system through
a nal single chase of the LED lights. After this, the keyboard has been registered on your computer as an HID
keyboard. You can now use the keyboard without any problems.
Using the CK4W for the rst time (wireless version)
Charging the keyboard:
• If a new keyboard is being used for the first time, first fully charge the battery. The
device must be switched on using the On/Off button before starting the charging process
Linking the dongle & keyboard:
• Place the USB dongle in one of your computer s USB ports.'
• Switch the keyboard on by pressing the On/Off button.
Once the k yboard has been switched on, the row of LED lights is illuminated sequentially (chase) and thee
USB dongle has a red light as long as the keyboard and the dongle have not been connected to each other. If
the LED lights do not come on after the keyboard has been switched on, there is not enough power in the
battery and it needs to be charged.
You create the connection between the two devices by briefly pressing the “Connect” button on the keyboard
and USB dongle.
As soon as the connection has been made, the chase goes off and the light on the dongle turns green.
• The keyboard is then ready for use.
Please note the following when using the CK4W:
As long as the connection between the dongle & the keyboard is established, the keyboard remains switched
on.
If the connection between the keyboard and the dongle is interrupted (e. g. switching off the PC), the keyboard
switches off automatically after 3 minutes. This is not a sleep or standby mode.
The keyboard is fact switched off (AKKU protection). You need to switch on the keyboard with the On/off in
button to use it again.
When shutting down the PC and the USB port (light of USB dongle is switched off), the CK4W can either be
switched off with the On/Off button or it switches itself off automatically after 3 minutes. If the USB port is not
switched off with shutting down the PC (USB dongle light remains green) the CK4W needs to be switched off
manually using the On/Off button.
Once the PC has been booted the keyboard needs to be switched on again using the On/Off button.
The pairing action (pressing the “Connect” button on the keyboard and the dongle) is, however, only necessary
when using the unit on a PC for the first time.
In order to charge the b ttery, the keyboard must also be switched on (using the On/Off button). a


Produkt Specifikationer

Mærke: GETT
Kategori: Tastatur
Model: CK4W

Har du brug for hjælp?

Hvis du har brug for hjælp til GETT CK4W stil et spørgsmål nedenfor, og andre brugere vil svare dig