Golden Lighting Colson 3167-4P Manual

Golden Lighting Lys Colson 3167-4P

Læs gratis den danske manual til Golden Lighting Colson 3167-4P (1 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Golden Lighting Colson 3167-4P, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

IMPORTANT:

• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.

• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!

• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!

CONNECTING THE WIRES

Have an assistant support the xture’s weight while completing the wiring. Cut away excess

wire. Attach the xture’s wires to the power supply wires from the junction box. Connect black

to smooth/black/transparent (L) wire; white to ribbed/white/transparent (N) wire; ground to

ground (green or copper). Twist the ends of the wire pairs together, and then twist on a wire

connector. Make sure all twists are in the same direction. If there is no ground wire (green

or copper) from the junction box, locate ground screw on mounting strap (A) and wrap the

xture’s ground wire around the green ground screw. Use a screwdriver to secure ground

screw onto the mounting bracket/mounting strap. Tuck all wires neatly into the junction box.

For Customer Service, contact

the place of purchase.

Assembly Instructions: 3167-4P, 6, 9 (Colson)

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn o the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.

PREPARING FOR INSTALLATION

Carefully remove all of the contents from the carton. See the important notes above. Shut o the

power at the circuit breaker and completely remove the old xture from the ceiling, including the old

mounting strap.

From the parts bag remove the mounting strap assembly. Mounting strap (A) contains threaded holes.

Two of mounting screws (C) should be attached to mounting strap (A). You may need to tighten the

nuts that hold these screws in place. Place mounting strap (A) over the junction box so that mounting

screws (C) are vertical, and in alignment with the hole locations on the xture’s canopy (D). Secure

mounting strap (A) to the junction box with mounting screws (B) and a screwdriver. Tighten the screws

securely.

FINISHING THE INSTALLATION

Push canopy (D) up to the ceiling and tightly thread nuts (E) onto the exposed threads of mounting screws (C).

Slide candle sleeves (J) over sockets (K). Install the bulbs (I - not included) into sockets (K) in accordance with the xture’s specications. Do not

exceed the maximum wattage

Your installation is now complete. Turn on the power and test the xture.