Golden Lighting Colson 3167-LP Manual

Golden Lighting Lys Colson 3167-LP

Læs gratis den danske manual til Golden Lighting Colson 3167-LP (1 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Golden Lighting Colson 3167-LP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

IMPORTANT:

• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.

• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!

• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!

CONNECTING THE

WIRES

Have an assistant support the xture’s weight while completing

the wiring. Cut away excess wire. Attach the xture’s wires to

the power supply wires from the junction box. Connect black

to smooth/black/transparent (L) wire; white to ribbed/white/

transparent (N) wire; ground to ground (green or copper). Twist

the ends of the wire pairs together, and then twist on a wire

connector. Make sure all twists are in the same direction. If there

is no ground wire (green or copper) from the junction box, locate

ground screw on mounting strap (A) and wrap the xture’s

ground wire around the green ground screw. Use a screwdriver

to secure ground screw onto the mounting bracket/mounting

strap. Tuck all wires neatly into the junction box.

For Customer Service, contact

the place of purchase.

Assembly Instructions: 3167-LP (Colson)

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn o the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.

PREPARING FOR INSTALLATION

Carefully remove all of the contents from the carton. See the important notes above. Shut o the power at the circuit breaker and completely

remove the old xture from the ceiling, including the old mounting strap.

From the parts bag remove the mounting strap assembly. Mounting strap (A) contains threaded holes. Two of mounting screws (C) should be

attached to mounting strap (A). You may need to tighten the nuts that hold these screws in place. Place mounting strap (A) over the junction box

so that mounting screws (C) are vertical, and in alignment with the hole locations on the xture’s canopy (D). Secure mounting strap (A) to the

junction box with mounting screws (B) and a screwdriver. Tighten the screws securely.

FINISHING THE INSTALLATION

Push canopy (D) up to the ceiling and tightly thread nuts (E) onto the exposed threads of mounting screws (C).

Slide candle sleeves (J) over sockets (K). Install the bulbs (I - not included) into sockets (K) in accordance with the xture’s specications. Do not

exceed the maximum wattage

Your installation is now complete. Turn on the power and test the xture.

ASSEMBLING THE FIXTURE

Shade (H) may be included with the xture. If the shade is included, please

check to see which side (top or bottom has the acrylic clip (N) attached.

Place shade (H) over the spherical arms (M) of the xture.

For adjusting the height of xture, this xture contains:

Three 12” rods (G) and one 6” rod (F). Each rod can be connected to another

by twisting the thread end of one into the opposite end of another. Each

rod may also be used to alone to connect the xture body to the swivel

(I2) on canopy (D). By measuring, decide the desired overall height of your

xture and determine how many rods are needed to achieve the desired