Golden Lighting Smyth 2073-4 Manual

Golden Lighting Lys Smyth 2073-4

Læs gratis den danske manual til Golden Lighting Smyth 2073-4 (1 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om Golden Lighting Smyth 2073-4, eller vil du spørge andre brugere om produktet?

Side 1/1
IMPORTANT:
• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.
• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!
• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!
PREPARING FOR INSTALLATION
PleaseNote:Thecage,andxturebody(R)arepre-assembled.Removeallofthecontentsfrom
thecarton.Seetheimportantnotesabove.Shutoffthepoweratthecircuitbreakerandcompletely
removetheoldxturefromtheceiling,includingtheoldmountingstrap.Fromthepartsbagremove
themountingstrapassembly.Oneendofnipple(F)shouldbeattachedtomountingstrap(A)with
Matchthethreadedholesofmountingstrap(A)tothespacingoftheholesonthejunctionbox.
Attachmountingstrap(A)tothejunctionboxusingmountingscrews(B)andascrewdriver.Tighten
securely.Unscrewcanopyloopcollar(I)fromcanopyloop(H).Passcanopy(G)overthemounted
canopylooptotesttheheight.Approximatelyhalfofthecanopyloop’sexteriorthreadsshouldbe
exposed,andthecanopyloopcollarshouldtsnuglyontothecanopyloop.Removecanopy(G)and
adjusttheheightofnipple(F)andcanopyloop(H)untilthedesiredheightisreached.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture. For deep cleaning, turn off the light
and remove the glass prior to cleaning. Hand wash glass with warm water and mild detergent. Dry with a lint-free or microber cloth.
AssemblyInstructions: (Smyth)2073-4, 2074-4
For Customer Service, contact the
place of purchase.
A
B
C
H
I
G
J
K
E
D
F
L
M
P
R
O
N
S
Q
ASSEMBLING THE FIXTURE
Placexturebody(R)ontoaatsurface.Rod(N)isonthexture’swires,butnot
attachedtothebodyofthexture.Passthexture’swiresthroughrod(N)andpull
thewiresuntiltaut.Twistrod(N)ontothepostatthecenterofthexturebody(R)until
secure.Bymeasuring,determinethecorrectnumberofchainlinksneededforproper
hangingheight.Ifnecessary,useapairofplierstoopenandremoveanyexcesschain.
Attachonechainconnector(K)toeachendofchain(J).Useoneofchainconnectors(K)
toattachchain(J)totoploop(L)andclosethechainconnector.Hooktheendofrod(N)
ontotoploop(L).Pullthewiresthroughtoploop(L).Feedthexture’swiresupthrough
thechain(everythreelinksorso),pullingthewiresuntiltaut.Slidecanopyloopcollar(H)
andcanopy(G)ontothechain/wires.Usethefreechainconnector(K)toattachchain(J)
tocanopyloop(H).
CONNECTING THE WIRES
Haveanassistantsupportthexture’sweightwhilecompletingthewiring.Cutaway
excesswire.Threadthexture’swiresthroughcanopyloopandnipple.Attachthe
xture’swirestothepowersupplywiresfromthejunctionbox.Connectblacktosmooth/
black/transparent(L)wire;whitetoribbed/white/transparent(N)wire;andgroundto
ground(greenorcopper).Twisttheendsofthewirepairstogether,andthentwistona
wireconnector.Makesurealltwistsareinthesamedirection.Ifthereisnogroundwire
(greenorcopper)fromthejunctionbox,locategroundscrew(E)onmountingstrap(A)
andwrapthexture’sgroundwirearoundthegreengroundscrew(E).Useascrewdriver
tosecuregroundscrew(E)ontothemountingbracket/mountingstrap.Tuckallwires
neatlyintothejunctionbox.
FINISHING THE INSTALLATION
Raisecanopy(G)totheceilingandslidecanopyloopcollar(I)upbeneaththecanopy.Tightlythreadcanopyloopcollar(I)ontocanopy
loop(H)tosecurecanopy(G)inplace.
Attachthehooksofrods(M)totoploop(L).Liftcage(P)upsothatrods(M)andxturebody(R)isinside.Holdcage(P)upandhave
anassistantattachthebottomloopsofrods(M)tothehooksinsidecage(P).Donotletgoofthecageuntilallrodsareattachedto
cage(P).Slidecandlesleeves(Q)overthesockets.Installlightbulbs(O)(notincluded)inaccordancewiththexture’sspecications.
Carefullyslideglassshades(S)overcandlesleeves(Q)andsecuretheglassinplacebypushingtheglassdownontothesockettters.
Yourinstallationiscomplete.Turnonthepowerandtestthexture.
Smooth / Black /
Transparent (L)
Black (Hot)
Ribbed / White /
Transparent (N)
Bare Copper / Transparent with
Green Interior / Green
White (Neutral)
Green
(Ground)


Produkt Specifikationer

Mærke: Golden Lighting
Kategori: Lys
Model: Smyth 2073-4

Har du brug for hjælp?

Hvis du har brug for hjælp til Golden Lighting Smyth 2073-4 stil et spørgsmål nedenfor, og andre brugere vil svare dig