3Introduction
4Important Safety Information
4Unpacking
5Front-Panel Controls
9Rear-Panel Audio Connections
11 Video and System Connections
13 Main Remote Control Functions
17 Zone II Remote Control Functions
18 Installation and Connections
21 System Configuration
21 Speaker Placement
21 System Setup
23 Input Setup
24 Audio Setup
24 Surround Select and Setup
26 Speaker Setup
28 Delay Settings
29 Output Level Adjustment
30 Tone Control
31 Video Setup
32 Advanced Video Configuration
34 Operation
34 Basic Operation
34 Source Selection
35 Volume and Tone Control
35 Video Processing
35 Surround Mode Selection
35 Digital Audio Playback
36 Surround Mode Chart
39 Tuner Operation
40 Recording
40 Front-Panel Connections
40 Output Level Trim Adjustment
42 Advanced Features
42 Front-Panel Display Fade
42 Display Brightness
42 Turn-On Volume Level
42 Semi-OSD Settings
43 Full-OSD Time-Out Adjustment
44 Multiroom Operation
44 Multiroom Setup
44 Surround Amplifier Channel Assignment
45 Multiroom Operation
46 Configuring the Remote
46 Programming Remote Codes
47 Learning Commands
48 Changing Devices
49 Macro Programming
51 Punch-Through Configuration
52 EzSet Configuration
53 Renaming
54 Resetting the Remote
56 Troubleshooting Guide
57 Appendix and Worksheets
59 Technical Specifications
See trademark acknowledgements on page 59.
Typographical Conventions
In order to help you use this manual with the remote control, front-panel controls and rear-panel connections,
certain conventions have been used.
EXAMPLE – (bold type) indicates a specific remote control or front-panel button, or rear-panel
connection jack
EXAMPLE – (OCR type) indicates a message that is visible on-screen or on the front-panel
information display
EXAMPLE – (Synchro type) indicates a message that is displayed on the remote control’s LCD screen
1– (number in a square) indicates a specific front-panel control
– (number in a triangle) indicates a front-panel control that is behind the drop-down door
å– (letter in a circle) indicates a rear-panel audio connection
A– (letter in a square) indicates a rear-panel video or system connection
a– (number in an oval) indicates a button or indicator on the remote
å
– (letter in an oval) indicates a button on the Zone II remote
®, HDCD®, High Definition Compatible Digital®and Pacific Microsonics
™
are either registered trademarks
or trademarks of Pacific Microsonics, Inc., in the United States and/or other countries. HDCD system manufactured
under license from Pacific Microsonics, Inc.
