Hayward AquaVac 650 Manual

Hayward Ikke kategoriseret AquaVac 650

Læs gratis den danske manual til Hayward AquaVac 650 (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 139 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 70 anmeldelser. Har du et spørgsmål om Hayward AquaVac 650, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/12
+
www.hayward-pool.com
Hayward Pool Products
620 Division Street
Elizabeth, NJ 07207
www.hayward.com
Hayward Pool Europe
1070 Allée des Chênes
01150 St-Vulbas, France
www.hayward.fr
Hayward Pool Products (Australia) Pty Ltd.
Melbourne-Sydney-Brisbane-Perth
P.O Box 4384, Dandenong South VIC. 3164
www.hayward-pool.com.au
Hayward Pool Products Canada
2880 Plymouth Drive
Oakville, ON L6H 5R4
www.haywardpool.ca
®
»»» Robotic Cleaner
AquaVac 6 Series
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be
observed including the following. Failure to adhere to the safety warnings below may result in
severe injury, death or property damage.
• Closely supervise children and pets at all times to ensure
they do not play with the cleaner – it is not a toy.
• Ensure that children do not attempt to access the cleaner
while it is operating.
• This appliance is not intended for use by persons with
reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by
a person responsible for their safety.
DO NOT PERMIT CHILDREN TO USE THIS PRODUCT.
• NEVER swim with the cleaner in the pool.
• Always disconnect and completely remove the cleaner
before entering the pool.
• All electrical wiring MUST be in conformance with applicable
local codes and regulations (See table at end of document).
Always follow local code requirements. Hazardous voltage
can shock, burn, and cause death or serious property damage.
• The cleaner should only be used with the provided cleaner
control unit, which supplies only Safety Extra Level Low
Voltage (SELLV) to the cleaner.
• The cleaner control unit shall be located at least 3.5 m (11.5 ft.)
from the closest edge of the pool.
• To reduce the risk of electric shock, DO NOT USE AN
EXTENSION CORD to connect control unit to electrical
outlet. This could create a safety hazard and/or damage
to the cleaner. Provide a properly located electrical outlet
per local building codes.
This is the . When you see this symbol on your equipment or in this manual, look safety-alert symbol
for one of the following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major
property damage and, if ignored, presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury
and/or property damage and, if ignored, presents a potential hazard. It also makes consumers
aware of actions that are unpredictable and unsafe.
READ AND FOLLOW ALL INSTRUCTIONS
WARNING - RISK OF INJURY
WARNING - RISK OF ELECTRICAL SHOCK
WARNING - RISK OF ELECTRICAL SHOCK
• Disconnect the cleaner control unit from the electrical
outlet before carrying out any user maintenance. Before
working on any equipment, disconnect control unit
from the equipment.
• Do not bury cable. Do not operate the cleaner with a
damaged cable. If the control unit power cord is damaged,
it must be replaced by the manufacturer, service agent, or
similarly qualied persons in order to avoid a hazard.
• In the , the cleaner control unit United States and Canada
must be connected only to a supply circuit protected by a
ground-fault circuit-interrupter (GFCI). Contact a qualied
electrician if you cannot verify that the circuit is protected
by a GFCI. This GFCI should be tested on a routine basis.
To test the GFCI, push the test button. The GFCI should
interrupt power. Push reset button. Power should be
restored. If the GFCI fails to operate in this manner, the
GFCI is defective. If the GFCI interrupts power to the
cleaner control unit without the test button being pushed,
a ground current is owing, indicating the possibility of
an electrical shock. Do not use the cleaner control unit.
Disconnect the cleaner control unit and contact the
manufacturer for assistance.
• In , the cleaner control Europe, Australia and New Zealand
unit must be supplied through a residual current device
(RCD) having a rated residual operating current not
exceeding 30 mA. Contact a qualied electrician if you
cannot verify that the circuit is protected by a RCD.
• Never allow the plug to enter the water.

Produkt Specifikationer

Mærke: Hayward
Kategori: Ikke kategoriseret
Model: AquaVac 650

Har du brug for hjælp?

Hvis du har brug for hjælp til Hayward AquaVac 650 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Hayward Manualer

Hayward

Hayward Pro Chem Manual

18 September 2025
Hayward

Hayward Plug N Clear Manual

12 August 2025
Hayward

Hayward Easy Chem Manual

2 September 2024
Hayward

Hayward SandMaster SM2306T Manual

10 August 2024
Hayward

Hayward Pro-Grid C9002SEP Manual

10 August 2024
Hayward

Hayward Navigator V-Flex HSC925CV Manual

10 August 2024
Hayward

Hayward ProSeries HB Manual

7 August 2024
Hayward

Hayward SharkVac XL Pilot Manual

6 August 2024
Hayward

Hayward PMD15 Manual

30 Juli 2024
Hayward

Hayward PMS15 Manual

23 Juli 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Sony

Sony AIBO ERS-7M2 Manual

3 Oktober 2025
AFK

AFK EWK-2200.73C Manual

3 Oktober 2025
TOA

TOA TS-D1000-DU Manual

3 Oktober 2025
Zoom

Zoom G1M Manual

3 Oktober 2025
Arris

Arris Touchstone TM902 Manual

3 Oktober 2025
Inkbird

Inkbird PTH-10C Manual

3 Oktober 2025
Rowenta

Rowenta Professional DW8115 Manual

3 Oktober 2025
AFK

AFK EWK-2200.5 Manual

3 Oktober 2025
Realme

Realme GT3 Manual

3 Oktober 2025
Supermicro

Supermicro SuperServer SYS-110D-4C-FRAN8TP Manual

3 Oktober 2025