Heath Zenith 6136 Manual


Læs gratis den danske manual til Heath Zenith 6136 (12 sider) i kategorien Controller. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Heath Zenith 6136, eller vil du spørge andre brugere om produktet?

Side 1/12
Wireless Lamp/
Outlet Modules
Models 6136 & 6138
Your wireless switched module system includes:
• Remotewallswitch
• Receiverlampmodule(SL-6138)oroutletmodule(SL-6136)
• Two#8x2"woodscrews
• Thismanual
You will need to buy a 9-volt alkaline battery for the wireless switch.Intypical
use,thisbatterywilllastoneyear.
Multiplechannels(AthruE)areavailablesothatyoucanoperateseveralsystems
atdifferentlocationsinyourhome.Ifyoupurchasemorethanonesystem,make
sureyouselectdifferentoperatingchannels,ortheywillinteractwitheachother.
Ifyoupurchaseadifferentswitchplatetomatchyourdecor,makesureitisnota
metalplate.Metalwallplateswillreducetheoperatingrange.
©2011HeathCoLLC 595-5627-05
Installation
1. Install the 9-volt battery.Removetheswitchcoverfromthe transmitteras
shown(savethetwoscrews).Snapthebatteryclipsoverthebatteryterminals
andsetthebatteryintoitscompartment.
Battery
Compartment
RemoteSwitch
-2- 595-5627-05
2. Turn off the power to the outlet or lamp to be controlled. Installthe
switchedoutletorlampmoduleasshown.
3. For the SL-6136, plug in the device(s) you wish to control. Screwthelight
bulbintotheSL-6138.Caution: donotexceedthespecicationslistedonthe
nextpage.Turnthepowerbackon.
4. To check the operation,holdtheremoteswitchatthedesiredlocationand
switch it on.The appliance shouldturn on immediately. Wait atImportant:
least3secondsafteryouswitchtheremoteswitchonoroffbeforeyouswitch
itagaintoallowthetransmissiontobecompleted.Turntheapplianceoffand
backonseveraltimes.Iftheswitchappearsunreliable,movetheremoteswitch
untiltheapplianceswitchesreliably.
5. Mount the remote switch at the desired location withthetwowoodscrewspro-
vided. Yourparticularinstallationmayrequiredifferentmountinghard-Note:
ware.
6. Install the switch plate on the remote switch
withthescrewsprovided.
SL-6136
SL-6138


Produkt Specifikationer

Mærke: Heath Zenith
Kategori: Controller
Model: 6136

Har du brug for hjælp?

Hvis du har brug for hjælp til Heath Zenith 6136 stil et spørgsmål nedenfor, og andre brugere vil svare dig