Sonance VC60R Manual

Sonance Controller VC60R

Læs gratis den danske manual til Sonance VC60R (2 sider) i kategorien Controller. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Sonance VC60R, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

INTRODUCTION

Thank you for purchasing this Sonance

component. Sonance

also offers the largest selection of high fidelity in-wall/

in-ceiling speakers in the world. Consult Sonance literature or

your Authorized Sonance Dealer for more information on the

wide variety of speakers, amplifiers, switchers, controls, cable,

and other custom installation products available from Sonance.

Please read these instructions carefully before connecting this

device to your system. If connections are made incorrectly you

may damage your amplifier/receiver.

IMPORTANT NOTE: TURN YOUR AMPLIFIER/RECEIVER OFF

BEFORE ATTEMPTING THE FOLLOWING HOOK-UP PROCEDURES.

VC30R APPLICATIONS

The VC30R is a rotary volume control. The volume can be

controlled by turning the knob clockwise to increase volume

and counterclockwise to decrease volume. This 10 position

rotary knob incorporates light touch silent switching

capabilities and can safely handle 30 watts per channel

of power.

WIRING AND PLACEMENT

DO NOT mount the volume control in the same electrical box

with AC house wiring, light switches, dimmers, or any other

high voltage device or control. The VC can share gang boxes

with other low voltage controls such as A/B speaker switches,

infrared receivers and emitters, and other volume controls if

these other devices are rated as Class 2 devices by the National

Electrical Code. With 14-18 gauge wire the volume control

between a single pair of speakers and the amplifier powering

those speakers. Run four wires for carrying speaker signals

(L+, L-, R+, and R-) from the amplifier, through the walls or

ceiling,to the volume control.We recommend high quality wire

like Sonance MediaLinQ

. If using free standing speakers, run

the wire through the wall or ceiling to a convenient location

near the speaker and terminate it with a Sonance FielDress

™

series system terminator or other audio jack.

INSTALLATION FOR VC30R (SEE DIAGRAM 1)

1.Once the speaker wires have been run,install a standard light

switch plaster ring or J-box that is approximately 3”in depth,

available from an electrical supply source.

2. TURN THE AMPLIFIER/RECEIVER POWER OFF. Then

connect the left or Channel-A speaker output, of the

amplifier/receiver, to the left screw-to-connect input terminals

of the volume control, observing proper polarity. For example

connect L+ of the amplifier to L+ of the VC, and L- to L-

(see diagram 2).

3. Repeat step 2 for the right or Channel-B speaker output.

4. Connect the left speaker wires to the left or Channel-A

output terminals of the volume control. Check proper polarity

of wires for correct speaker phase. For example connect the +

terminal of the speaker to the + VC output, and - to -

(see diagram 2).

5. Repeat step 4 for the right or Channel-B speaker connection.

MOUNTING THE CONTROLS:

Once the unit has been wired,position the volume control with

terminals at top, and attach it to a standard light switch plaster

ring or J-box. Use the included screws to attach the

volume control to the plaster ring or box. Attach the wallplate

to the control using the screws provided. DO NOT OVER-

TIGHTEN THE PLATE SCREWS OR YOU MAY DAMAGE THE

PLATE. Finally, attach the knob to the control shaft

(See Diagram 3).

OPERATION

Determine the maximum volume you wish to feed to the rooms

in which you have volume controls and speakers. With your

house music source (amplifier/receiver) turned down, turn the

volume control(s) all the way up. Feed the amplifier/receiver a

strong music signal, then gradually increase the

amplifier/receiver volume until the volume in the room(s) is as

loud as you are likely to ever listen.Take particular care that no

audible distortion is heard through your speakers or speaker

damage will occur.If you are using an amplifier with input level

controls,such as the Sonance Sonamp

series amplifiers,adjust

the level controls appropriately. Then return to the rooms with

volume controls and lower the volume settings to normal

listening levels. Setting the maximum volume will ensure safe

operation for speakers and amplifiers. If you think there should

be sound coming from your speakers but do not hear anything

when the VC is turned all the way up, DO NOT leave it in the

full ON position when checking your sources or source

material. Otherwise there may be a startling increase in

volume when the problem is remedied, and speaker damage

may occur.

SPECIFICATIONS

Power Rating: 30 Watts RMS MAX INPUT/CH

Switch Type: 10 Position Light Touch Switch

Frequency Response: 20-20KhZ ±2dB

Speaker Impedance: 8Ω

Dimensions (WxHxD)Overall: 1-13/16" x 4" x 2-1/4"

(45mm x 102mm x 57mm)

In-Wall 1-13/16" x 2-7/8" x 2-1/4"

(45mm x 73mm x 57mm)

I N S TA L L AT I O N I N S T R U C T I O N S

V C 3 0 R R O T A R Y I N - W A L L

S T E R E O V O L U M E C O N T R O L

PN.33-1517 9/98

Produkt Specifikationer

Mærke:	Sonance
Kategori:	Controller
Model:	VC60R

Har du brug for hjælp?

Hvis du har brug for hjælp til Sonance VC60R stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Controller Sonance Manualer

Sonance VC60R Manual

2 April 2025

Sonance VC30R Manual

8 Januar 2025

Controller Manualer

Nyeste Controller Manualer

Trust Mylox GXT 735G Manual

30 Marts 2025

Trust Mylox GXT 735 Manual

30 Marts 2025

American DJ STAGE SETTER-8 Manual

30 Marts 2025

American DJ DP-DMX20L Manual

30 Marts 2025

Visual Productions TimeCore Manual

30 Marts 2025

PCE Instruments PCE-RE22T Manual

28 Marts 2025

Turtle Beach Recon Manual

27 Marts 2025

AMX MU-3300 Manual

26 Februar 2025

PowerA Enhanced Wireless Controller Manual

26 Februar 2025

IPEGA PG-9078 Manual

20 Februar 2025