
To test the UPS on battery mode, cut off the utility and UPS observes
“backup indicator” lights, then your PC can continue working normally.
Ba
Ba
Ba
BaBatt
tt
tt
tttte
e
e
eery ra
ry ra
ry ra
ry rary rati
ti
ti
titing
ng
ng
ngng
Communication software download address:
https www hikvision com en support download software:// . . / / / / /
COMMUNICATION SOFTWARE DOWNLOAD
/ : - - - -S N PN CC625 70033 08D10 08140
110V: 110/115/120VAC; 220V: 220/230/240VAC
110V: 85~145 VAC; 220V: 175~275VAC
110V: 110/115/120VAC; 220V: 220/230/240VAC
110V: 102~132 VAC; 220V: 200~240VAC
Push the switch for 3 seconds , (the LCD displayinput & output voltage).
then the UPS will be ready for operation.
1. Self-testing while switching on
In Battery Mode, shortly press the switch will enable or disable the buzzer.
But when UPS is low battery or overloaded, the buzzer can not be silenced.
In DC mode, UPS discharges till battery run out and cut off, UPS autorun
When UPS is overloaded on operation, it will cut off the output
automatically if it is not solved by the user in time.
When the battery is about to be exhausted, UPS will shut down automatically
to protect battery s life.
UPS will cut off the output and goes to AC standby mode by pressing the
Press the switch for 3 seconds, the UPS will be turned off after a long beep.
The trouble shooting chart covers most of the difficulties that you may
encounter under normal working conditions. If the UPS fails to operate
properly, please review the following steps before calling the service center.
1. Is the UPS plugged into a correct working outlet?
2. Is the line voltage within the rating specified?
3. Is the fuse or breaker / ciruit protector on back panel open?
1. Model No. & Serial No.
3. Full description of problem.