– 2 –
© HOBART, 2017
Installation, Operation and Care of
MODEL 84145 FOOD CUTTER
SAVE THESE INSTRUCTIONS
GENERAL
The Model 84145 Food Cutter is designed to cut and mix a
wide variety of products. With products in the rotating 14"
(355mm) stainless steel bowl, rotating knives cut and mix
them inside the bowl cover. The food cutter is powered by
a 1/2 horsepower motor and is available for single- or three-
phase electrical service.
The Model 84145 is furnished with a #12 attachment hub.
Various attachments for this model, available through Hobart,
include: #12 Meat and Food Chopper; #12 Vegetable Slicer;
#12 Dicer/French Fry Cutter; and #12 Speed Drive (for use
with #12 Vegetable Slicer only).
INSTALLATION
UNPACKING
The food cutter was inspected before leaving the factory. The carrier assumes full responsibility for the safe
delivery upon acceptance of the shipment. Check for possible shipping damage immediately after receipt.
If the food cutter is found to be damaged, complete the following steps:
1.Carriermustbenotiedwithinvebusinessdaysofreceipt.
2.Carrier'slocalterminalmustbenotiedimmediatelyupondiscovery(notetime,date,andwhowas
spokento),andfollowupandconrmwithwrittenorelectroniccommunication.
3. All original packing materials must be kept for inspection purposes.
4.Thefoodcuttercannothavebeenmoved,installed,ormodied.
5. Notify Hobart customer care at (800) 333-7447.
Priortoinstallation,testtheelectricalservicetoassurethatitagreeswiththespecicationsonthemachine
dataplate.Itisimportanttocheckknifeclearancebeforeturningonthemachineforthersttime.Ifthe
knife touches the bowl or bowl cover, contact your local Hobart Servicer.
LOCATION
With the legs installed, place the machine on a sturdy level surface.
ELECTRICAL CONNECTIONS
The supply cord on this machine is provided with a three-prong or four-prong
grounding plug. It is imperative that this plug be connected to a properly grounded, mating
receptacle. If the receptacle is not the proper grounding type, an electrician should be contacted.
