Honeywell COB02 Manual


Læs gratis den danske manual til Honeywell COB02 (9 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Honeywell COB02, eller vil du spørge andre brugere om produktet?

Side 1/9
Charge-Only Base
COB02
Installation Guide
Rev B
9/15
Introduction
Honeywell’s Charge-Only Base can fully charge an industrial
wireless area-imaging scanner in 5 hours, maximizing uptime in any
application.
Note: When a scanner is placed into the Charge-Only Base, the
battery will charge. Please note that the Charge-Only Base
will not facilitate communication with the host system or other
scanners.
Installation
Connect the power adapter to the Charge-Only Base, then plug the
power supply into an AC power outlet. Make sure the AC power
outlet voltage is the same as the power supply.
Use only a Listed Limited Power Source (LPS) or Class 2 type
power supply with output rated 5 to 5.2Vdc, 1A. We recommend
use of Honeywell power adapters. Use of any non-Honeywell
power adapters may cause damage not covered by the
warranty.


Produkt Specifikationer

Mærke: Honeywell
Kategori: Ikke kategoriseret
Model: COB02

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell COB02 stil et spørgsmål nedenfor, og andre brugere vil svare dig