Honeywell CT33A1009/E1 Manual

Honeywell Termostat CT33A1009/E1

Læs gratis den danske manual til Honeywell CT33A1009/E1 (16 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Honeywell CT33A1009/E1, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
Owner’s Manual
English: Page 1
Mode d’emploi
Français : Page 6
Manual de Uso
Español: Página 11
CT30 Series
Low-Voltage Thermostat
M37781
69-2338EFS-04
M23786
MERCURY NOTICE
If your old thermostat contains
mercury, contact your local waste
management authority for proper
disposal instructions.
TURN OFF POWER at heating/cooling system (or fuse/circuit-breaker panel).
Remove cover and thermostat, but leave wallplate with wires attached.
Is there a sealed tube containing mercury?
If so, see mercury notice below.
Leave wallplate in place.
Old thermostat
Cover
Getting started
Remove your old thermostat
Check package contents:
• Thermostat
• Coverplate
• Wall anchors & screws (2 each)
• Caution card
• Wire labels
Before you begin, make sure you have:
• No. 2 Phillips & small pocket screwdrivers
• Hammer
• Level (optional)
• Pencil
• Drill and bit (3/16” for drywall, 7/32” for
plaster)
CT30 Series • Owner's Manual
69-2338EFS—04 2
0
0
0
M23787
Wrap supplied labels securely around each wire. Do not let wires fall into wall opening!
IGNORE WIRE COLORS: Use only letter
designations to identify wire types.
For CT31: If your old thermostat
has 5 or more wires (not counting
terminals C or C1), you may have
purchased the wrong replacement
thermostat. Stop now and call
1-800-468-1502 for advice.
1. Pull wires
through base
(CT31 only).
2. Level base if
desired.
3. Mark positions
of both screw
holes.
For CT30/CT33: If your old
thermostat has 3 or more wires
(not counting terminals C or C1),
you may have purchased the wrong
replacement thermostat. Stop
now and call 1-800-468-1502 for
advice.
Use a screwdriver to disconnect wires one by one. As you disconnect each wire, wrap it with
the label matching the letter on your old thermostat. (Adhesive labels are supplied in your
thermostat package.)
Remove the old wallplate only after all wires are labeled. Be careful not to let loose wires fall into
the wall opening.
Label wires and remove old wallplate
Mark mounting position
CT30/CT33 CT31

Produkt Specifikationer

Mærke: Honeywell
Kategori: Termostat
Model: CT33A1009/E1

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell CT33A1009/E1 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Termostat Honeywell Manualer

Honeywell

Honeywell CT50K1028/E Manual

12 August 2025
Honeywell

Honeywell RET97B5D1002/U Manual

12 August 2025
Honeywell

Honeywell RCHT9510WFW2001/W Manual

12 August 2025
Honeywell

Honeywell CT87K1004/E1 Manual

12 August 2025
Honeywell

Honeywell YCT87N1006 Manual

12 August 2025
Honeywell

Honeywell RTH7500D1049/A Manual

12 August 2025
Honeywell

Honeywell YCT50K1006 Manual

12 August 2025
Honeywell

Honeywell RTH2510B1000/U Manual

12 August 2025
Honeywell

Honeywell RTH221B1039/E1 Manual

12 August 2025
Honeywell

Honeywell RLV3150A1004/E Manual

12 August 2025

Termostat Manualer

Nyeste Termostat Manualer

Daikin

Daikin BRC1H519W Manual

11 August 2025
Daikin

Daikin BRC1D528 Manual

11 August 2025
Carrier

Carrier Infinity SYSTXCCITC01-B Manual

10 August 2025
Hager

Hager WXF315 Manual

9 August 2025
Hama

Hama 176592 Manual

9 August 2025
Eberle

Eberle UTE 1002 Manual

7 August 2025
Eberle

Eberle UTE 1012 Manual

7 August 2025
Eberle

Eberle SSR-E 6905 Manual

7 August 2025
JUNG

JUNG CD 500 Manual

7 August 2025
Levoit

Levoit Aura Sensor LTM-AS041S-WUS Manual

6 August 2025