Hotpoint HIO 3P23 WLE - Ultima Manual

Hotpoint Opvaskemaskine HIO 3P23 WLE - Ultima

Læs gratis den danske manual til Hotpoint HIO 3P23 WLE - Ultima (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 61 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 31 anmeldelser. Har du et spørgsmål om Hotpoint HIO 3P23 WLE - Ultima, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
1
EN
DAILY REFERENCE
GUIDE
THANK YOU FOR BUYING A HOTPOINT PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.hotpoint.eu/register
You can download the Safety Instructions and the Use
and Care Guide, by visiting our website
docs.hotpoint.eu and following the Instructions on the
back of this booklet.
Before using the appliance carefully read Health and Safety guide.
PRODUCT DESCRIPTION
APPLIANCE
1. Upper rack
2.
Cutlery rack
3. Foldable flaps
4. Upper rack height adjuster
5. Upper spray arm
6. Lower rack
7. Space Zone
8. Lower spray arm
9. Filter Assembly
10.Salt reservoir
11.Detergent and Rinse Aid dispensers
12.Rating plate
13.Control panel
0000 000 00000
Service:
1
4
5
6
11
13
7
12
10
8
9
2
3
CONTROL PANEL
1. On-Off/Reset button with indicator light
2. Program selection button
3. Salt refill indicator light
4. Rinse Aid refill indicator light
5. Program number and remaining time indicator
6. Delay indicator light
7. Display
8. Zone Wash 3D indicator light
9. Delay button
10.
Zone Wash 3D
button
11. Tablet (Tab) button with indicator light
12. Turbo button with indicator light
13. Extra Dry button with indicator light
1 2 3 4 5 6 7 8 9 10 11 12 13
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
• It is important that the salt reservoir be never empty.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher (see
PROGRAMS DESCRIPTION) and should be filled when the SALT REFILL
indicator light in the control panel is lit.
1.Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2.Position the funnel
(see figure)
and fill the salt
reservoir right up to its edge (approximately 1 kg);
it is not unusual for a little water to leak out.
3.Remove the funnel and wipe any salt residue
away from the opening.
4. Remove the funnel and wipe any salt residue away from the
opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, we recommend carrying out the
procedure before the washing cycle is started.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory setting is for average (3) water hardness.
• Switch on the appliance by pressing the ON/OFF button.
• Switch off the appliance by pressing the ON/OFF button.
• Hold down button P for 5 seconds, until you hear a beep.
• Switch on the appliance by pressing the ON/OFF button.
• The current selection level number and the salt indicator light both flash.
• Press button P to select the desired hardness level (see WATER
HARDNESS TABLE).
• Switch off the appliance by pressing the ON/OFF button.
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specifically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL
indicator light switches off.
If the salt container is not filled, the water softener and the heating
element may be damaged as a result.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser A should
be filled when the RINSE AID REFILL indicator light in the control
panel is lit.
1. Open the dispenser
B
by pressing and pulling up the tab on the lid.
2. Carefully introduce the rinse aid as far as the maximum (110 ml)
reference notch of the filling space - avoid spilling it. If this happens,
clean the spill immediately with a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisfied with the drying results, you can ad-
just the quantity of rinse aid used.
• Switch the dishwasher on using the ON/OFF button.
• Switch it off using the ON/OFF button.
• Press button P three times - a beep will be heard.
• Switch it on using the ON/OFF button.
• The current selection level number and rinse aid indicator light flash.
• Press button P to select the level of rinse aid quantity to be
supplied.
• Switch it off using the ON/OFF button
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied. The
LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 4 levels can be set according to the dishwasher model.
The factory setting is for a medium level.
• If you see bluish streaks on the dishes, set a low number (1-2).
• If there are drops of water or limescale marks on the dishes, set a
high number (3-4).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser
use the opening device A. Introduce
the detergent into the dry dispenser
B only. Place the amount of
detergent for pre-washing directly
inside the tub.
1.When measuring out the detergent
refer to the mentioned earlier
information to add the proper
quantity. Inside the dispenser
B
there
are indications to help the detergent dosing.
2. Remove detergent residues from the edges of the dispenser and
close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the
TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
1 Soft 0 - 6 0 - 10
2 Medium 7 - 11 11 - 20
3 Average 12 - 17 21 - 30
4 Hard 17 - 34 31 - 60
5 Very hard 35 - 50 61 - 90
M
A
X
A
B
35
25
A
B

Produkt Specifikationer

Mærke: Hotpoint
Kategori: Opvaskemaskine
Model: HIO 3P23 WLE - Ultima

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint HIO 3P23 WLE - Ultima stil et spørgsmål nedenfor, og andre brugere vil svare dig


Opvaskemaskine Hotpoint Manualer

Hotpoint

Hotpoint H8F HP51BS UK Manual

25 Juli 2025
Hotpoint

Hotpoint H8F HP51X UK Manual

25 Juli 2025
Hotpoint

Hotpoint HA7IA15B2M6LS0 Manual

16 Juli 2025
Hotpoint

Hotpoint HA6IB16B2M6LS0 Manual

16 Juli 2025
Hotpoint

Hotpoint HA6IC16B4M6H0 Manual

16 Juli 2025
Hotpoint

Hotpoint HA2IE10CS80 Manual

15 Juli 2025
Hotpoint

Hotpoint HSIC 3M27 C S Manual

15 Juli 2025
Hotpoint

Hotpoint HA4ID11CS80 Manual

20 Juni 2025
Hotpoint

Hotpoint HA6IB16B2M6L0 Manual

19 Juni 2025
Hotpoint

Hotpoint HA6IA14BN7A0 Manual

18 Juni 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

BEKO

BEKO BDFS16030W Manual

30 Juli 2025
BEKO

BEKO BDFN36540PA Manual

30 Juli 2025
BEKO

BEKO BDFN15440B Manual

30 Juli 2025
Fisher & Paykel

Fisher & Paykel DW60U4EI3 Manual

30 Juli 2025
BEKO

BEKO BDFN26451W Manual

30 Juli 2025
BEKO

BEKO BDFN15440G Manual

30 Juli 2025
Haier

Haier XF 4A4M0W-80 Manual

30 Juli 2025
BEKO

BEKO BDFN15440W Manual

30 Juli 2025
Kernau

Kernau KDI 6753 Manual

29 Juli 2025
Candy

Candy CH 3E7F0S Manual

29 Juli 2025