Hotpoint RAB80 Manual

Hotpoint Ikke kategoriseret RAB80

Læs gratis den danske manual til Hotpoint RAB80 (16 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 48 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 24.5 anmeldelser. Har du et spørgsmål om Hotpoint RAB80, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
1
31-5000176 10-18 GEA
Standard Metal Wall Sleeve
Packaged Terminal Air Conditioner RAB80
Installation
Instructions
BEFORE YOU BEGIN
Read these instructions carefully and completely.
Ŷ IMPORTANT – Save these instructions for
local inspector’s use.
Ŷ IMPORTANT – Observe all governing codes
and ordinances.
Ŷ Note to Installer – Be sure to leave these instructions
with Consumer.
Ŷ Note to Consumer – Keep these instructions for
future reference.
Ŷ Skill level – Installation of this appliance requires
basic mechanical and electrical skills.
Ŷ 3URSHULQVWDOODWLRQLVWKHUHVSRQVLELOLW\RIWKHLQVWDOOHU
Ŷ 3URGXFWIDLOXUHGXHWRLPSURSHULQVWDOODWLRQLVQRW
FRYHUHGXQGHU:DUUDQW\
Subbase Installations
When installing a subbase to support the sleeve or an
electrical receptacle for the power cord, the sleeve must
project a minimum of 2 3/4 inches into the room to have room
for the subbase and receptacle box. The sleeve must be
installed between 3 1/4 to 5 1/2 inches (maximum) above floor
(including carpeting).
IMPORTANT: If the sleeve projects more than 4 inches into a
room, the maufacturer recommends that a subbase or leveling
OHJVDFFHVVRU\DUHDGGHGWRSUHYHQWWKHVOHHYHIURPVDJJLQJ
or cantilevering into the room.
Wall Preparation
3URSHUDWWHQWLRQWRZDOOSUHSDUDWLRQRSHQLQJVL]HDQGJRRG
contruction practices are essential to a trouble-free sleeve
installation.
Wall Opening Size: Recommended minimum wall
opening is 42 1/4” wide by 16 1/8” high.
Wood/steel Framing: Build a frame to the minimum wall
RSHQLQJVL]HWRVXSSRUWWKHVOHHYHDVVKRZQ
Framing and Minimum Wall Sleeve Opening
Header 4” x 4” or
(2) 2” x 4” on edge
Jack Stud
Cripple
Main Stud
Floor
Sub-Floor
Jack Stud
42 1/4”
16 1/8”
Masonry Walls: Create the recommended minimum wall
RSHQLQJ´ZLGHE\´KLJK7KHVOHHYHZLOOQRW
VXSSRUWFRQFUHWHEORFNRUEULFNV8VHSURSHUVL]HGOLQWHOVWR
support block or bricks above wall opening. The sleeve should
EHIDVWHQHGWRPDVRQU\ZDOOVZLWKPDVRQU\VFUHZVILHOG
supplied). If the opening is framed in wood, use wood screws
to secure the sleeve.
Curtain Walls: Use case angles to create the recommended
PLQLPXPZDOORSHQLQJ´ZLGHE\´KLJKIRU
installations such as curtain walls, window walls, or where the
structural material of the wall is insufficient to support or fasten
the wall sleeve to. Case angles are pieces of steel or similar
material that are formed to a 90° angle. Add holes to fasten the
case angle to the sleeve and to the structural component of
the wall Do not drill holes into the bottom of the sleeve.
Introduction
These instructions cover the installation of the standard
PHWDOZDOOVOHHYHWKURXJKPDVRQU\VWHHORUZRRGIUDPH
walls. Fasteners are field supplied. The air conditioner and
UHDUJULOOHDUHVKLSSHGVHSDUDWHO\
The sleeve is shipped
unassembled. It must be field assembled prior to installation.
IMPORTANT: DO NOT remove thermal insulation from
sleeve.
Packaged Contents
INSIDE
BOTTOM
Weather
Barrier
Top Panel
Right Side
Panel
Bottom
Panel
Left Side
Panel
Push Pins
A corrugated weather barrier is also included. If required, it
FDQEHDWWDFKHGWRWKHUHDURIWKHVOHHYHWRSURYLGHWHPSRUDU\
weather protection.
Selecting Location
Use the following guide for selecting the proper sleeve
location
7KHVOHHYHPD\EHLQVWDOOHGDJDLQVWWKHIORRULQFOXGLQJ
carpet), except for installations using subbase. See
Subbase Installations section.
2. For cord-connected air conditioner, an electrical receptacle
must be located within reach of the power cord.
6WDQGDUG3RZHU&RUG/HQJWKLQPP
Voltage Right of Sleeve/HIWRI6OHHYH
230/208v 30 (762) 70 (1778)
265v  
&RQVXOWDLUFRQGLWLRQHUPDQXIDFWXUHU¶VVSHFLILFDWLRQVIRUDFWXDOSRZHUFRUG
length.
7KHYFRUGZLOOQRWH[WHQGEH\RQGERWWRPRIDLUFRQGLWLRQHU

Produkt Specifikationer

Mærke: Hotpoint
Kategori: Ikke kategoriseret
Model: RAB80

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint RAB80 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Hotpoint Manualer

Hotpoint

Hotpoint HDE6VDCX Manual

3 September 2025
Hotpoint

Hotpoint SH8 A2Q WRD UK Manual

30 Juni 2025
Hotpoint

Hotpoint DIH 10D1 IX Manual

26 Juni 2025
Hotpoint

Hotpoint HBNF 55182 Manual

27 Februar 2025
Hotpoint

Hotpoint FFU3D K 1 Manual

27 Februar 2025
Hotpoint

Hotpoint UHA6 F2C W Manual

2 September 2024
Hotpoint

Hotpoint HFC 3C26 CW X Manual

28 August 2024
Hotpoint

Hotpoint HFC 3C26 F Manual

28 August 2024
Hotpoint

Hotpoint HFC 3B19 X Manual

28 August 2024
Hotpoint

Hotpoint HSFO 3T235 WC X Manual

28 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

NUX

NUX Mighty 20 BT Manual

2 Januar 2026
Chapin

Chapin 88400B Manual

2 Januar 2026
WAC Lighting

WAC Lighting H-LED160 Manual

2 Januar 2026
Mikrotik

Mikrotik DynaDish 6 Manual

2 Januar 2026
SIME

SIME Murelle Equipe 70 ErP Manual

2 Januar 2026
Signature Hardware

Signature Hardware Sheba 462905 Manual

1 Januar 2026
Jones Stephens

Jones Stephens B0RPZLCP Manual

1 Januar 2026
NUX

NUX Stageman NMP-4 Manual

1 Januar 2026
WAC Lighting

WAC Lighting R4RNT-25 Manual

1 Januar 2026
Delta

Delta H777 Manual

1 Januar 2026