Hozelock 1800 Manual


Læs gratis den danske manual til Hozelock 1800 (78 sider) i kategorien Vandpumpe. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Hozelock 1800, eller vil du spørge andre brugere om produktet?

Side 1/78
air pump 1500
1810
?
2
Hozelock Ltd.
Midpoint Park,
Birmingham B76 1AB. England
Tel: +44 (0) 121 313 1122
info@hozelock.com
www.hozelock.com
33132-001
INSTALLATION AND OPERATING INSTRUCTIONS.
READ INSTRUCTIONS CAREFULLY BEFORE
ATTEMPTING INSTALLATION. KEEP THESE
INSTRUCTIONS FOR FUTURE REFERENCE.
The Hozelock Cyprio air pump is designed for use
outdoors. It must not be submersed in the pond. All
electrical components are safely housed inside the
product.
The appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the appliance.
1. WARNING: ALWAYS UNPLUG OR DISCONNECT
ALL APPLIANCES IN THE POND FROM THE
ELECTRICITY SUPPLY BEFORE PUTTING YOUR
HANDS IN THE WATER WHILST EQUIPMENT IS
BEING INSTALLED, REPAIRED, MAINTAINED OR
HANDLED.
2. Do not use the supply cable to lift the pump as
this may cause damage.
3. If the supply cable is damaged, do not operate
the pump.
4. Do not operate or leave the pump in freezing
conditions.
5. Check that the voltage marked on the pump
corresponds to the mains supply.
6. A 30mA maximum Residual Current Device (RCD)
MUST be fitted to the mains supply.
7. Do not operate this pump without the inlet filter
and cover attached. Using the pump without AN
INLET FILTER may invalidate your warranty.
1. The pump is supplied with 3m of 3-core electric
cable, which is permanently connected and sealed
to the motor. The supply cable cannot be
replaced. If the cable is damaged, the pump
should be discarded. This product is designed to
be permanently wired to the mains supply in a
dry weatherproof enclosure through a Double-
Pole Switched Fused Spur - (Disconnector) - Fitted
with a 3 or 5 Amp fuse. The installation must
conform to the national and local wiring
regulations.
2. A 30MA MAXIMUM RESIDUAL CURRENT DEVICE
(RCD) MUST BE FITTED TO THE MAINS SUPPLY.
3. WARNING: This appliance must be earthed.
4. If an extension cable is required, this should be
connected to the end of the pump cable using a
weatherproof cable connector. The joint must be
positioned in a suitable weatherproof housing.
The extension cable should be of 3 core 0.75mm
2
Polychloroprene rubber insulated cable (ref: HO5
RN-F) and permanently wired to the mains supply
with a 3 or 5 Amp fuse.
5. The pump cable (and extension cable) should be
adequately protected against damage especially
where contact with gardening equipment (lawn
mowers, forks etc..) children and domestic
animals may occur.
6. Always disconnect the mains power supply whilst
the equipment is being installed, repaired,
maintained or handled. Consult a qualified
electrician or local authority if in any doubt about
wiring to the mains supply.
IMPORTANT:
MAXIMUM DEPTH OF AIR STONE IN POND 2M. BY
PLACING THE AIR STONE DEEPER THAN 2M YOU
WILL FOREGO THE PRODUCT WARRANTY.
1. Place the unit near the pond, on a solid level
surface. Route the cable back to the mains supply.
Ensure that you allow for enough cable for
positioning the product in the desired location
near the pond.
2. Push the rubber outlet pipe over the outlet of the
Air Pump and fasten in place using the metal clip
provided (See Fig 1 & 2).
3. Insert the air manifold into the end of the rubber
tube and fasten in place with the clip provided
(See Fig 3 & 4).
4. Push the 4mm air tube onto the end of one of
the air outlets and ensure it is securely in place
(See Fig 5).
5. To fit the non-return valve to the air pipe, cut the
pipe and push the ends onto the inlet/outlet of
the valve. This valve only works in one direction,
which is indicated by the mark ‘OUT’ (See Fig 6).
This valve ensures that water is not sucked back
into the pump if the pump is installed below the
pond’s water level when the power supply is
turned off.
6. Cut the air tube to the desired length. This will be
determined by:
a) The location of your pump around the pond
b) The depth at which you want to position your air
stone in the pond (MAXIMUM DEPTH = 2m).
Important
Warning: Safety and Electrical
Connections
Pump Installation


Produkt Specifikationer

Mærke: Hozelock
Kategori: Vandpumpe
Model: 1800

Har du brug for hjælp?

Hvis du har brug for hjælp til Hozelock 1800 stil et spørgsmål nedenfor, og andre brugere vil svare dig