IFi Audio micro iPhono2 Manual

IFi Audio Hi-Fi system micro iPhono2

Læs gratis den danske manual til IFi Audio micro iPhono2 (15 sider) i kategorien Hi-Fi system. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om IFi Audio micro iPhono2, eller vil du spørge andre brugere om produktet?

Side 1/15
Set-Up Guide
iFi iPhono 2 Quick Cartridge Setup Guide
Step 1: Select and Connect MM/MC Input.
The cartridge manual will tell you the output voltage of the cartridge.
Eg The output voltage of a the MC cartridge Denon DL- 103R is 0.25mV;
The output voltage of a the MM cartridge Shure M97xE is 4mV.
Thus the Shure M97xE (4mV) should be connected to the MM input of the iPhono; the
Denon DL 103R (0.25mV) should be connected to the MC input of the iPhono.-
Note: MM MC and inputs should not be connected simultaneously.
Tip: For a High Output MC cartridge like the Ortofon -3 MC Turbo, its output is 3.3mV
so it should be
connected to the MM input of the iPhono. The actual output voltage determinates which input should
be used.
Tip: Remember to connect the ground wire from the turntable to the iPhono2 I. f
required, use the small extension lead included for ease of connection.
Step 2: Select and Set Gain.
Most - phono pre amplifiers have gain adjustment levels. Different cartridges require
different gain s. MM cartridges require lower gain and MC cartridge require higher gain. level
Normally gain is expressed in decibel (dB); dB means times gain. 36 63
The iPhono 2 allows gain s from 36dB (63 times) to 72dB (4,000 times) to be set level
allowing for Cartridges with rated outputs from <= 0.1mV to >= 10mV eaning your choice . M
of cartridge is completely free and not limited by the iPhono 2.
C artridge Output
Gain Required
Input & Switch Settings
> 4.8mV
36dB
MM
1 .2 mV 4.8 mV
48 dB
MM & +12dB
0.3 .2 - 1 mV
60dB
MC
< 0.3 mV
72dB
MC & +12dB
Cartridge output
iPhono 2 input connection
< 1 .2 mV
MC
1 .2 mV
MM
1
Set-Up Guide
From the the previous table, Shure M97xE 40dB 103R should should use gain, and Denon DL-
use 66dB gain. As long as the right connection (MM/MC) is made as per Step 1: Connect
MM/MC Input,’ there is no need to distinguish MM/MC cartridge anymore for the following
steps.
Steps to set gain
(i) Please look at the output voltage of the cartridge;
(ii) Connect the cable from the turntable to the correct input (Step 1)
(iii) Determinate the gain required (dB) from the table overleaf;
(iv) S et the micro switches exactly as follows, ignore the grayed out switches for
now.
Tip: If you are not sure which gain to set as your cartridge output is near the borderlevel line of
recommendations, first choose the lower gain. Increase gain if you cannot get satisfactory volume
levels at your desired volume control setting on your Amplifier/Preamplifier.
MM - 36dB Gain
2


Produkt Specifikationer

Mærke: IFi Audio
Kategori: Hi-Fi system
Model: micro iPhono2

Har du brug for hjælp?

Hvis du har brug for hjælp til IFi Audio micro iPhono2 stil et spørgsmål nedenfor, og andre brugere vil svare dig