Ignis G0F L634O Manual

Ignis Opvaskemaskine G0F L634O

Læs gratis den danske manual til Ignis G0F L634O (4 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 83 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 42 anmeldelser. Har du et spørgsmål om Ignis G0F L634O, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

ENQuick Guide

PROGRAMS TABLE

Program Programs description

Drying

phase

Auto

Door

Available options *)

Duration

of wash

program

(h:min)**)

Water

consumption

(litres/cycle)

Energy

consumption

(kWh/cycle)

Eco 50°- Eco program is suitable to clean normally soiled ta-

bleware. that for this use. it is the most ecient program in

terms of its combined energy and water consumption. and

that it is used to assess compliance with the EU Ecodesign leg-

islation.

3:10 9.5 0.85

2. Auto Intensive 65° - Automatic program for heavily soiled

dishes and pans (not to be used for delicate items). 2:00 - 3:10 14.0 - 17.0 1.50 - 1.85

Auto Mixed 55° - Automatic program for normally soiled pans

and dishes.

1:30 - 2:30 14.5 - 16.0 1.15 - 1.30

Fast&Clean 28’ 45° - Program to be used for half load of light-

ly-soiled dishes with no dried food residues. Does not have

drying phase. - 0:28 9.0 0.60

5. Pre-Wash - Use to refresh crockery planned to be washed lat-

er. No detergent to be used with this program. - - 0:10 4.0 0.01

ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020. Note for Test Laboratories: For information on

comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com

Pre-treatment of the dishes is not needed before any of the programs.

*) Not all options can be used simultaneously.

**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature and

pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor cali-

bration. The sensor calibration can increase program duration up to 20 min.

CONTROL PANEL

1. On-O/Reset button with indicator

light

2. Program selection button with

indicator light

3. Half Load button with indicator light

4. Rinse Aid rell indicator light

5. Salt rell indicator light

6. Program indicator lights

7. Delay indicator light

8. Delay button with indicator

light

9. Tablet (Tab) button with

indicator light

10. Start/Pause button with

indicator light / Drain out

FIRST TIME USE

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and on

the machine’s functional components.

• It is mandatory that the salt reservoir never be empty.

• It is important to set the water hardness.

The salt reservoir is located in the lower part of the dishwasher and must be

lled when the SALT REFILL indicator light in the control panel is lit.

1. Remove the lower rack and unscrew the reservoir cap

(anticlockwise).

2. Only the rst time you do this: ll the salt reservoir

with water.

3. Position the funnel and ll the salt reservoir (see gure)

right up to its edge (approximately 1 kg); it is not unu-

sual for a little water to leak out.

4. Remove the funnel and wipe any salt residue away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get into the

container during the wash program (this could damage the water softener be-

yond repair). Whenever you need to add salt, it is mandatory to complete the

procedure before the beginning of the washing cycle to avoid corrosion.

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse

aid dispenser should be lled when the A RINSE

AID REFILL indicator light in the control pan-

el is lit. NEVER pour the rinse aid directly into the

appliance tub.

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser use the opening device . Introduce the C

detergent into the dry dispenser only. Place the amount of detergent for D

pre-washing directly inside the tub.

If all-in-one detergents are used, we recommend using the TABLET button,

because it adjusts the program so that the best washing and drying results

are always achieved.

Usage of detergent not designed for dishwashers may cause malfunc-

tion or damage to the appliance.

WATER SOFTENING SYSTEM

Water softener automatically reduces water hardness, consequently pre-

venting scale buildup on heater, contributing also to better cleaning e-

ciency. This system regenerates itself with salt, therefore it is required

to rell salt container when empty.

Frequency of regeneration depends on water hardness level setting - regen-

eration takes place once per 6 Eco cycles with water hardness level set to 3.

Regeneration process starts in nal rinse and nishes in drying phase, be-

fore cycle ends.

• Single regeneration consumes: ~3.5L of water;

• Takes up to 5 additional minutes for the cycle;

• Consumes below 0.005kWh of energy.

854 6 97 10

THANK YOU FOR BUYING AN IGNIS PRODUCT.

Before using the appliance carefully read the Safety Instruction.

PLEASE SCAN THE QR CODE ON YOUR

APPLIANCE IN ORDER TO HAVE MORE

DETAILED INFORMATION

Quick GuideEN

TROUBLESHOOTING Please scan on your product in order to have more detailed information. the QR code

PROBLEMS POSSIBLE CAUSES SOLUTIONS

The dishwasher

does not ll the

water.

All LEDs are blink-

ing rapidly

No water in the water supply or the tap is closed. Make sure there is water in the water supply or the tap running.

The inlet hose is bent. Make sure the inlet hose is not bent (see INSTALLATION) reprogram the dishwasher and

reboot.

The sieve in the water inlet hose is clogged; it is

necessary to clean it.

After having carried out the verication and cleaning, turn o and turn on the dish-

washer and restart a new program.

Dishwasher nishes

the cycle prematurely.

Drain hose positioned too low or siphoning into

home sewage system.

Check if end of drain hose is placed at correct height (see INSTALLATION).Check for

siphoning into home sewage system, install air admittance valve if necessary.

Air in water supply. Check water supply for leaks or other issues letting air inside.

LOADING THE RACKS CAPACITY: 14 standard place-settings

UPPER RACK

(loading example for the upper rack)

Load delicate and light dishes: glass-

es, cups, saucers, low salad bowls.

FOLDABLE

FLAPS WITH

ADJUSTABLE

POSITION

LOWER RACK

For pots, lids, plates,

salad bowls, cutlery

etc. Large plates and

lids should ideally be

placed at the sides to

avoid interferences

with the spray arm.

The lower rack has tip-

up supports which can

be used in a vertical po-

sition when arranging

plates or in a horizontal

position (lower) to load pans and salad bowls easily.

CUTLERY BASKET

It is tted with top

grids for improved

cutlery arrange-

ment. It must only

be positioned at

the front of the

lower rack.

Knives and oth-

er utensils with

sharp edges must be placed in the

cutlery basket with the points facing

downwards or they must be posi-

tioned horizontally in the tip-up com-

partments on the upper rack.

(loading example for the

lower rack)

More information in the Daily Reference Guide on website.

CLEANING AND MAINTENANCE

CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS

In case you nd foreign objects (such as broken glass, porcelain, bones, fruit seeds etc.)

please remove them carefully.

NEVER REMOVE the wash-cycle pump protection (black detail) (Fig 4).

To remove the upper spray arm,

turn the plastic locking ring in a

clockwise direction.

The lower spray arm may be

removed by pulling it up-

wards.

Policies, standard documentation, ordering of spare parts and additional product information can be found by:

• Using QR code on your product.

• Visiting our website docs.ignis.eu and parts-selfservice.europeanappliances.com

• Alternatively, (See phone number in the warranty booklet). When contacting our After-contact our After-sales Service

sales Service, please state the codes provided on your product‘s identication plate.

The model information can be retrieved using the QR-Code reported in the energy label. The label also includes the model

identier that can be used to consult the portal of the registry at https://eprel.ec.europa.eu.

IEC 436

DELAY - 2, 4It is possible to delay the start time of the program by or

8 hours:

The DELAY function cannot be set once a wash cycle has been started.

TABLET (Tab) f you use powder or liquid detergent, this option - I

should be o.

OPTIONS AND FUNCTIONS

OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL). If an option is not compatible with the selected program

(see PROGRAMS TABLE), the corresponding LED ashes rapidly 3 times and beeps will sound. The option will not be enabled.

HALF LOAD - If there are not many dishes to be washed, a half load-

ing may be used in order to save water, electricity and detergent.

Remember to halve the amount of detergent.

Please scan the on your product in order to have more detailed information. QR code

AUTO DOOR is a convection drying system which automatically

opens the door during/after drying phase to ensure exceptional dry-

ing performance every day. Door opens at the temperature that is

safe to your kitchen furniture.

Produkt Specifikationer

Mærke:	Ignis
Kategori:	Opvaskemaskine
Model:	G0F L634O

Har du brug for hjælp?

Hvis du har brug for hjælp til Ignis G0F L634O stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Opvaskemaskine Ignis Manualer

Ignis GIC 3C26 Manual

18 September 2025

Ignis G0F L634O Manual

4 November 2024

Ignis ADL 349/A/1 IG Manual

9 Oktober 2024

Ignis ADL 335 Manual

9 September 2024

Ignis G0I D534A Manual

3 September 2024

Ignis G2I HD526 A Manual

29 August 2024

Ignis ADL 353 Manual

22 August 2024

Ignis adl 934 six Manual

22 August 2024

Ignis adl 833 2 Manual

22 August 2024

Ignis ADL 448-4 Manual

20 August 2024

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Signature SDW8002EWNE Manual

18 September 2025

Vestel BMA 4202 X WIFI Manual

17 September 2025

Midea SF 3.45NW PRO Manual

17 September 2025

Saivod LVT4525INOX Manual

17 September 2025

Saivod LVC725 Manual

17 September 2025

Midea MDWEF1433DSS-WE Manual

17 September 2025

Vestel BM 5312 X WIFI Manual

17 September 2025

Saivod LVT825 INOX Manual

17 September 2025

Midea MDWEF1034DSS-WE Manual

16 September 2025

Midea SV 5.14K14C Manual

16 September 2025