1. For initial use, wash detachable parts thoroughly with soap and water except
2. Assemble the Citrus Juicer (See How To Assemble).
3. Use Small Cone Reamer for lime, lemons, etc. and use the Large Cone
Reamer for oranges, ponkan, etc.
4. Cut the citrus fruits into half.
5. Plug the unit into the convenience outlet.
One hand will hold the handle for support, place the citrus fruit in the cone
lid and pressing the citrus fruit towards the cone reamer, it will
NOTE: To control the juice from dripping, simply put the spout into close
position. (Push the spout upward).
6. Unplug the unit after use.
CLEANING AND MAINTENANCE:
1. Unplug the unit from the convenience outlet.
2. Wipe or clean the outside surface with a damp or soft cloth.
NEVER IMMERSE BASE UNIT IN WATER OR OTHER LIQUID.
4. Always be sure to wring excess water out of cloth or sponge when cleaning
around any electrical part.
5. Do not use abrasive materials to avoid scratches.
Lid – Remove the cone lid by pressing it downward and wash in warm soapy
water. Rinse under clean running water and dry. Reassemble before use.
Accessories (Cone Reamer, Strainer, Anti-drip Spout)
If the citrus juicer was left sitting until there is dried, crusty juice bits inside: Put
the accessories into a wash basin with warm, soapy water (or vinegar water) and
let sit for about 30 to 60 seconds. Empty the basin and rinse the accessories with
- Turn OFF the unit and wait for the unit to stop.
- Always unplug the unit after every use.
- Wipe the accessories with soft cloth to dry. Make sure to reassemble
the unit properly before storing it.
- Never leave juice inside the citrus juicer for a long period of time.
- Store the citrus juicer on a dry cool place.
NOTE: NEVER ALLOW THE BOTTOM OF THE BLADE TO GET WET.
1. Unplug the unit from the convenience outlet before cleaning.
2. All parts are washable with soap and water except the base unit.
3. Wipe the base unit with damp cloth.
4. Place the cord into its proper place after use.
5. Dry all parts before reassembling the unit.
6. Do not use abrasive materials to avoid scratches.
REMINDER: Please do not forget to ll up and send the warranty card with
receipt to our email address imarexfb@evergoodinc.com
