1. Make sure that the appliance is in position before plugging in the ‘0’
2. Assemble the Juicer (See How to Assemble)
3. Wash the fruits/vegetables and remove the skin and seeds:
If using fruit with hard or inedible skins such as mangoes, melons or
pineapple, always peel before juicing
Citrus fruit can be juiced. Simply remove the skin and seeds
All fruits with pits, hard seeds or stones from nectarines, peaches,
mangoes, apricots, plums and cherries must be removed before
Be sure to cut the fruit or vegetable into pieces, no larger than 2
inches for optimal extraction, and remove any large hard seeds.
4. Put a cup or container under the Juice Spout.
5. Select the desired speed by turning the speed selector.
Speed I Function is for juicing soft vegetables, soft fruits or any –
Speed Function is for juicing hard vegetables and hard fruits II –
6. Juice will ow into the cup or container through the juice spout and the
separated pulp will accumulate in the pulp container. Always watch the
level of juice in the cup or container. Do not overll, as juice will continue
to drip from the cup or container after you have stopped juicing. Switch
OFF the unit and allow the drippings to stop before removing the cup or
NOTE: THE UNIT WAS EQUIPPED WITH OVERLOAD
PROTECTION. IT WILL AUTOMATICALLY STOP WHEN THE
MOTOR GET HOT. UNPLUG THE UNIT THEN LET IT COOL.
7. Unplug every after use.
CLEANING AND MAINTENANCE:
It is important to thoroughly clean the unit after each use to avoid the buildup
1. Make sure to switch o and unplug the unit before moving or cleaning
2. Detachable parts can be washed using soap and water.
3. For consistent juicing results always ensure that the filter and blade is
thoroughly cleaned. Using a nylon brush, hold the lter and blade under
running water and brush from the inside to outer rim. If the holes are
blocked, soak the lter and blade in hot water with 10% lemon juice to
loosen the blocked holes.
4. Some vegetables such as carrot may cause discoloration of the plastic,
to avoid discoloration wash thoroughly after use.
5. Dry all parts thoroughly, then assemble the juice extractor and turn the
power ON to spin out any excess water in the Filter/Blade Assembly.
6. Wipe the base of the unit with damp cloth.
7. Do not use abrasive materials to avoid scratches.
Note: Do not immerse the unit in water or any other liquid.
REMINDER: Please do not forget to ll up and send the warranty card
with receipt to our email address imarexfb@evergoodinc.com
Distributed By: Evergood Unlimited Corp.
901 G.Masangkay St., Manila
