Inday HDDA-1 Manual

Inday Modtager HDDA-1

Læs gratis den danske manual til Inday HDDA-1 (2 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Inday HDDA-1, eller vil du spørge andre brugere om produktet?

Side 1/2
Overview And Uses
HDDA-1
HDTV
Wideband Analog
Distribution
Amplifier
Phone: 503-575-1951
Email: support@inday.com
INDAY
1818 NE 140th
Portland, Oregon 97230
For Customer Service:
The HDDA-1 is a very wideband analog Distribu-
tion Amplifier (DA) capable of buffering and split-
ting any nominal 1 to 2 Volt (peak to peak) signal
that terminates into 75 ohms. This includes any of
the following.
- H
DTV Analog RGB/YPbPr signals
.
- Sta
ndard Def. Analog RGB/YPbPr/Betacam
- Co
mponent DVD, Progressive or Interlac
ed.
- C
omposite Video (NTSC)
- SPDIF
Digital Audio (PCM/AC3
/DTS)
Figure 1 - Connectors
Figure 2 - Component Video Distribution
The HDDA-1 can be configured in a number of
ways. Here are the most common.
A
1-In to 4-Out HDTV Receiver or Progress
ive
Scan
DVD Splitter. Figure
2
A 1
-In to 10 out Composite Distribution Amp to
feed a stack of Dubbing VCR’s. Figure
3
Three
separate 1-In to 4-Out DA’s. Figure
4.
Hom
e Theater. One input distributes the Com-
posite (NTSC) video to the Displays and anot
her
in
put distributes the Digital Audio to the Audio
equipment. Figure
5
Th
e unit is supplied with the proper 12VDC Power
Supply (center pin positive +).
Configurations
Figure 3 - Composite Video Distribution 1X10
Multimedia Accessories
Multimedia Accessories
Configurations Continued
INPUT:
3 Gold Plated RCA
Each 75 Ohm Terminated
Color Coded: Red, Green, Blue
Nominal Signal should be 1 Vp-p.
Maximum of 4 Vp-p.
OUTPUT:
12 Gold Plated RCA
Color Coded: 4 Red, 4 Green, 4 Blue
Impedance 75 ohms
Noise > 60dB below 1Vp-p
Frequency Response DC-220 Mhz +/-.3dB
POWER:
12VDC (18VDC Max) @ 150ma Max.
Wall Transformer supplied
DIMENSION:
4"W x 6"L x 2"H
TEMPERATURE
0 TO 50 DEGREES C
HUMIDITY
0 TO 90% (non-condensing)
Disclaimer
This manual has been checked for accuracy. Inday
assumes no liability for damages incurred directly
or indirectly from errors or omissions or from the
use and suitability of this product for a particular
application.
Revision 1.1 1/28/2002
Q: Why No Looping Inputs.
A: Looping inputs are ones that bridge off an unter-
minated input and send it to another input. This
lets you daisy chain the inputs and terminate only
at the last input. This works fine for Low Fre-
quency video like NTSC (composite) at 5MHz,
but not for High Frequency HDTV where fre-
quencies can reach over 100 MHz. The input
must be terminated to prevent reflections on the
cable and maintain bandwidth.
Q: Can I split Analog Audio with this DA.
A: Yes, but the level (Volume) can drop from 2dB to
30dB due to the low input impedance (75 ohms).
Some audio equipment with low enough output
impedance can feed this DA with acceptable re-
sults, but most will have a high impedance that
will cause unacceptable signal loss.
Q: Can I split Digital Audio (SPDIF).
A: Yes. SPDIF is just AES/EBU digital audio that is
designed to run over Coax cable just like video.
Q: Could I use the Splitter for my Computer VGA
output?
A: Yes. It would require 2 HDDA-1’s and a bunch
of adapters. One DA is required for the RGB Sig-
nals and another for the H and V Sync signals.
Questions
Specifications
Figure 4 - Three Separate Splitters
Figure 5 - Home Theater with Video and Digital Audio
Three Video Sources


Produkt Specifikationer

Mærke: Inday
Kategori: Modtager
Model: HDDA-1

Har du brug for hjælp?

Hvis du har brug for hjælp til Inday HDDA-1 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Modtager Inday Manualer

Inday

Inday SVDA-1 Manual

2 Oktober 2025
Inday

Inday HDDA-1 Manual

1 Oktober 2025
Inday

Inday HDDA-2 Manual

1 Oktober 2025

Modtager Manualer

Nyeste Modtager Manualer