Indesit IN2IE14DNP80 Manual

Indesit Opvaskemaskine IN2IE14DNP80

Læs gratis den danske manual til Indesit IN2IE14DNP80 (4 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 41 personer og har en gennemsnitlig bedømmelse på 3.9 stjerner ud af 21 anmeldelser. Har du et spørgsmål om Indesit IN2IE14DNP80, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

ENQuick Guide

CONTROL PANEL

ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.

Note for Test Laboratories:

For information on comparative EN testing conditions, please send an email to the following address:

dw_test_support@europeanappliances.com

Pre-treatment of the dishes is not needed before any of the programs.

*) Values given for programmes other than the eco programme are indicative only. The actual time may vary depending on many factors such as temperature

and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor

calibration. The sensor calibration can increase program duration up to 20 min.

PROGRAMS TABLE

1 2 43 5

1. ON-OFF / Reset button with indicator light

2. Program selection button / Push&GO

3. Salt rell indicator light

4. Program indicator lights

5. START/Pause button with indicator light

Program Programs description

Drying

phase

Duration

of wash

program

(h:min)*)

Water

consumption

(litres/cycle)

Energy

consumption

(kWh/cycle)

Eco 50°- Eco program is suitable to clean normally soiled tableware, that for this

use, it is the most ecient program in terms of its combined energy and water

consumption, and that it is used to assess compliance with the EU Ecodesign le-

gislation.

4:30 12.0 0.95

2. Intensive 65° - Program recommended for heavily soiled crockery, especially

suitable for pans and saucepans (not to be used for delicate items). 2:30 16.0 1.50

3. Mixed - 55° Mixed soil. For normally soiled dishes with dried food residues. 2:25 16.0 1.35

4. Fast&Clean 28’

45° -

Program to be used for half load of lightly-soiled dishes with

no dried food residues. Does not have drying phase. -0:28 9.0 0.60

5. Push&GO - 50° Everyday wash and dry cycle that ensures great cleaning perfor-

mance in a short time without the need to pre-treat dishes. 1:25 11.5 1.10

PUSH&GO

Push&GO button (P) is an easily distinguishable button that allows you direct access to the Push&GO program, a wash and dry cycle that ensures great

cleaning performance in a short time. You don’t have to worry which program to choose, Push&GO cycle will do the work for you.

To select Push&GO program, switch on appliance, press only button for 3 seconds (corresponding indicator lights up) and close the door within 4 seconds.P

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and on

the machine’s functional components.

• It is mandatory that THE SALT RESERVOIR NEVER BE EMPTY.

• It is important to set the water hardness.

The salt reservoir is located in the lower part of the dishwasher and must be

lled when the SALT REFILL indicator light in the control panel is lit.

1. Remove the lower rack and unscrew the reservoir cap

(anticlockwise).

2. Only the rst time you do this: ll the salt reservoir

with water.

3. Position the funnel (see gure) and ll the salt reservo-

ir right up to its edge (approximately 1 kg); it is not

unusual for a little water to leak out.

4. Remove the funnel and wipe any salt residue away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get into

the container during the wash program (this could damage the water so-

ftener beyond repair).

Whenever you need to add salt, it is mandatory to complete the

procedure before the beginning of the washing cycle to avoid corrosion.

WATER SOFTENING SYSTEM

Water softener automatically reduces water hardness, consequently

pre-

venting scale buildup on heater, contributing also to better cleaning

eciency.

This system regenerates itself with salt, therefore it is required to rell

salt container when empty.

Frequency of regeneration depends on water hardness level setting - regen-

eration takes place once per 5 Eco cycles with water hardness level set to 3.

Regeneration process starts in nal rinse and nishes in drying phase, be-

fore cycle ends.

• Single regeneration consumes: ~3.5L of water;

• Takes up to 5 additional minutes for the cycle;

• Consumes below 0.005kWh of energy.

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse aid

dispenser A should be lled when when the dark

optical indicator on the dispenser door becoC-

mes transparent.

NEVER pour the rinse aid directly into the

appliance tub.

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser use the opening device . Introduce the D

detergent into the dry dispenser only. Place the amount of detergent for E

pre-washing directly inside the tub.

Usage of detergent not designed for dishwashers may cause malfunc-

tion or damage to the appliance.

FIRST TIME USE More information in the Daily Reference Guide on website.

THANK YOU FOR BUYING AN INDESIT PRODUCT.

In order to receive a more complete assistance, please

PLEASE SCAN THE

QR CODE ON YOUR

APPLIANCE IN

ORDER TO HAVE

MORE DETAILED

INFORMATION

Before using the appliance carefully read Safety and Installation Instructions.

After installation, please remember to remove all transport protection parts from

the dishwasher.

UPPER RACK

(loading example for the

upper rack)

Load delicate and light

dishes: glasses, cups, saucers,

low salad bowls.

LOWER RACK

(loading example for the

lower rack)

For pots, lids, plates, salad

bowls, cutlery etc.. Large

plates and lids should ide-

ally be placed at the sides

to avoid interferences with

the spray arm.

FOLDABLE

FLAPS

WITH AD-

JUSTABLE

POSITION

CUTLERY BASKET

The basket is equipped with top

grilles for improved cutlery arrangement.

The cutlery basket should be positioned only at the front of the lower rack.

Knives and other utensils with sharp edges must be placed in the

cutlery basket with the points facing downwards or they must be po-

sitioned horizontally in the tip-up compartments on the upper rack.

More information in the Daily Reference Guide on website.

LOADING THE RACKS

CLEANING AND MAINTENANCE

CAPACITY: 14 standard place-settings

PROBLEMS POSSIBLE CAUSES SOLUTIONS

The dishwasher does

not ll the water.

All LEDs are

blinking rapidly

No water in the water supply or the tap is

closed. Make sure there is water in the water supply or the tap running.

The inlet hose is bent. Make sure the inlet hose is not bent (see INSTALLATION) reprogram the dishwa-

sher and reboot.

The sieve in the water inlet hose is clogged;

it is necessary to clean it

After having carried out the verication and cleaning, turn o and turn on the

dishwasher and restart a new program.

Dishwasher nishes

the cycle prematurely. Drain hose positioned too low or siphoning

into home sewage system.

Check if end of drain hose is placed at correct height (see INSTALLATION).Check

for siphoning into home sewage system, install air admittance valve if necessary.

Air in water supply. Check water supply for leaks or other issues letting air inside.

Detergent leaks.

Depends on the liquid detergent used and

can be emphasized in case of delay option

is activated.

Small leaks will not cause machine malfunction and can be avoided by changing

liquid detergent type or using tablets.

In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following list. For other errors or issues

please contact authorized After-sales Service which contact details can be found in the warranty booklet. Spare parts will be available for a period

of either up to 7 or up to 10 years, according to the specic Regulation requirements.

TROUBLESHOOTING

CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS

In case you nd foreign objects (such as broken glass, porcelain, bones, fruit seeds

etc.) please remove them carefully.

NEVER REMOVE the wash-cycle pump protection (black detail) (Fig 4).

To remove the upper spray arm,

turn the plastic locking ring in a

clockwise direction.

The lower spray arm may

be removed by pulling it

upwards.

Please scan on your product in order to have more detailed information. the QR code

Policies, standard documentation, ordering of spare parts and additional product information can be found by:

• Using QR code on your product.

• Visiting our website docs.indesit.eu and parts-selfservice.europeanappliances.com

• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting our After-

sales Service, please state the codes provided on your product‘s identication plate.

The model information can be retrieved using the QR-Code reported in the energy label. The label also includes the model

identier that can be used to consult the portal of the registry at https://eprel.ec.europa.eu.

IEC 436

Produkt Specifikationer

Mærke:	Indesit
Kategori:	Opvaskemaskine
Model:	IN2IE14DNP80

Har du brug for hjælp?

Hvis du har brug for hjælp til Indesit IN2IE14DNP80 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Opvaskemaskine Indesit Manualer

Indesit IN2IE14CNP80 Manual

10 Juni 2025

Indesit IN2FE14CNP80 Manual

20 Februar 2025

Indesit IN2IE14DNP80 Manual

24 Januar 2025

Indesit idl 600 Manual

15 Januar 2025

Indesit idl 410 fr c Manual

15 Januar 2025

Indesit ID3I D741O Manual

14 Januar 2025

Indesit D2F HK26 S Manual

30 December 2025

Indesit UNODUE Manual

11 Oktober 2024

Indesit DG 6445 W Manual

22 September 2024

Indesit DSRL 17B19 Manual

17 September 2024

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Bosch SMS6HMI01I Manual

15 Juni 2025

Bosch SMV2IVX00K Manual

15 Juni 2025

Bosch SMS6HVI01I Manual

15 Juni 2025

Bosch SHE43CM5N Manual

15 Juni 2025

Bosch SMS6ZCW00X Manual

15 Juni 2025

Bosch SMS66GW01I Manual

15 Juni 2025

Bosch SMS66GI01I Manual

15 Juni 2025

Pelgrim GVWC210L Manual

15 Juni 2025

Bosch SPV4HMX65K Manual

15 Juni 2025

Bosch SMS6HMI00I Manual

15 Juni 2025