Follow the instructions on the symbols of the garment’s wash
care label. The value indicated in the symbol is the maximum
recommended temperature for washing the garment.
Sport: a cycle designed for washing lightly soiled sports clothing
(tracksuits, shorts, etc.); for best results, we recommend not exceeding the
maximum load indicated in the “Wash Cycle Table”. We recommend using liquid
detergent and adding the amount suitable for a half-load.
Dark: use programme 2 to wash dark-coloured garments. This
programme is designed to maintain dark colours over time. We
recommend using a liquid detergent for the best results when washing
dark-coloured garments.
When you select the drying function, at the end of the washing cycle the
machine will automatically perform a delicate drying cycle that preserves the
colours of the garments. The display will show the level “ ”. Max. load: 3 kg.
Anti-odour: use programme 3 for washing garments with bad odours
(e.g. smoke, sweat, fried food). The programme is designed to remove bad
odours while preserving the fabric bres. Synthetics fabrics or mixed
loads should be washed at 40°, and resistant cotton fabrics at 60°.
Delicate: use programme 4 to wash very delicate garments. It is
advisable to turn the garments inside out before washing them. For best
results, use liquid detergent on delicate garments.
When selecting an exclusively time-based drying function, a drying cycle is
performed at the end of the wash cycle that is particularly delicate, thanks
to light handling and appropriate temperature control of the water jet.
The recommended durations are:
1 kg of synthetic garments --> 150 min
1 kg of synthetic and cotton garments --> 180 min
1 kg of cotton garments --> 180 min
The degree of dryness depends on the load and fabric composition.
Wool - Wool Care:
The wool wash cycle of this machine has been approved by
The Woolmark Company for the washing of machine washable
wool products provided that the products are washed
according to the instructions on the garment label and those
issued by the manufacturer of this washing machine. The
Woolmark symbol is a Certication mark in many countries.
(M2227)
Rapid 30’: this programme is designed to wash lightly soiled
garments at 30° (excluding wool and silk) with a 3 kg
maximum load in a short time: it only lasts 30 minutes and allows for
saving time and energy.
White Cotton 90°C: suitable for resistant linen and cotton that are heavily
soiled.
Synthetic: suitable for washing moderately soiled garments made of
synthetic bres (e.g. polyester, polyacrylic, viscose, etc.) or mixed
synthetic-cotton bres.
Coloured: a 30°C cycle that helps to preserve colours, suitable for cotton
or synthetic coloured garments. It allows for reducing electricity
consumption for heating the water while guaranteeing good washing
results. Suitable for lightly soiled garments.
Eco Cotton 60°: suitable for washing moderately soiled cotton garments.
At 60°C it is the standard cycle for washing cotton garments, and is the
most ecient in terms of combined water and electricity consumption.
Eco Cotton 20°C: ideal for lightly soiled cotton loads. The eective
performance levels achieved at cold temperatures, which are comparable
to washing at 40°, are guaranteed by a mechanical action which operates
at varying speed, with repeated and frequent peaks.
Eco Synthetic 20°C: ideal for mixed loads (cotton and synthetics) with a
normal soil level. The eective performance levels achieved at cold
temperatures are guaranteed by a mechanical action which operates at
varying speed, across set average intervals.
Wash&Dry 45’: select programme 13 for washing and drying lightly
soiled garments (Cotton and Synthetic) in a short time. This cycle may be
used to wash and dry a laundry load of up to 1 kg in just 45 minutes. To
achieve optimum results, use liquid detergent and pre-treat cus, collars
and stains.
AirFresh: ideal cycle to refresh garments and remove bad odours, in
particular smoke, from cotton and synthetic items in 30’ (max. 1.5 kg)
without the washing phase.
Rinse: designed for rinsing.
Spin + Drain: designed to spin and drain the water.
DISPLAY
The display is useful when programming the machine and provides a lot
of information.
The duration of the available wash cycles and the remaining time of a
running cycle appear in section ; if the Delayed Start option has been A
set, the countdown to the start of the selected cycle will appear.
Pressing the corresponding button allows you to view either the
the machine during the set wash cycle, or the values selected most
recently (if compatible with the set wash cycle).
The hourglass ashes while the machine processes the data on the basis of the
selected cycle. After a maximum of 10 minutes, the icon remains steady lit
and the nal time remaining is displayed. The “hourglass” icon will then switch
o approximately 1 minute after the nal time remaining has been displayed.
The “washing phases” relative to the selected cycle and the “washing
phase” of the running cycle appear in section :B
Wash
Rinse
Spin/ Drain
Drying
When lit, the symbol indicates that the set “Delayed Start” value has
appeared on the display.
There are three levels in section relative to the washing options.C
Section includes the icons related to the three dierent drying levels as D
well as the icon , which lights up when a timed drying option is set.
Door locked indicator
When lit, the symbol indicates that the door is locked. To prevent any
damage, wait until the symbol turns o before opening the door.
To open the door while a cycle is in progress, press the START/PAUSE
button ; if the symbol is o, the door can be opened.
FIRSTTIME USE
Once the appliance has been installed, and before it is used for the rst
time, run a wash cycle with detergent and no laundry, by setting the
“Auto-Clean” cycle.
DAILY USE
Prepare the laundry by following the suggestions appearing under the
“TIPS AND SUGGESTIONS” section.
Rapid programming
- Press the ON/OFF button ; the START/PAUSE indicator light will
ash slowly green.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the cycle table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments as described in “DETERGENT DISPENSER DRAWER”
section.
- Close the door.
STARTING CYCLE
Press the PUSH & WASH + DRY button.
The machine will lock the door ( symbol on) and the drum will start to
rotate; the door will be unlocked ( symbol o) and then locked again
( symbol on) as preparation phase of each washing cycle. The “Clicking”
noise is part of the door locking mechanism. Water will enter the drum
and start the washing phase once the door is locked.
Traditional programming
- Press the ON/OFF button ; the START/PAUSE indicator light will
ash slowly green.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the Wash Cycle Table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments as described in “DETERGENT DISPENSER DRAWER”
section.
- Close the door.
- Use the WASH CYCLE selector knob to select the desired wash cycle: it
will be associated with a specic temperature and spin speed that can be
modied. The duration of the cycle will appear on the display.
- Modify the temperature and/or spin speed: the machine automatically
displays the maximum temperature and spin speed values set for the
selected cycle, or the most recently-used settings if they are compatible
with the selected cycle. Pressing the button gradually reduces the
temperature down to the cold wash “OFF” setting. Pressing the button
gradually reduces the spin speed until it is completely excluded (“OFF”
setting). Pressing these buttons again restores the maximum values.
- Select the desired options.
STARTING CYCLE
Press the START/PAUSE button.
The machine will lock the door ( symbol on) and the drum will start to
rotate; the door will be unlocked ( symbol o) and then locked again
( symbol on) as preparation phase of each washing cycle. The “Clicking”
noise is part of the door locking mechanism. Water will enter the drum
and start the washing phase once the door is locked.
PAUSING A CYCLE
To pause the wash cycle, press the START/PAUSE button again; the
indicator light will ash amber. If the symbol is not lit, the door may be
opened. To start the wash cycle from the point at which it was
interrupted, press the START/PAUSE button again.
OPENING THE DOOR, IF NECESSARY
Once a cycle starts, the symbol turns on to signal that the door cannot
be opened. While a wash cycle is running, the door remains locked. To
open the door while a cycle is under way, for example, to add or remove
garments, press the START/PAUSE button to pause the cycle; the
indicator light will ash amber. If the symbol is not lit, the door may be
opened. Press the START/PAUSE button again to continue the cycle.
CHANGING A RUNNING WASH CYCLE
To change a wash cycle while it is in progress, pause the washer-dryer using the
START/PAUSE button (the relative indicator light will ash amber), then
select the desired cycle and press the START/PAUSE button again.
! To cancel a cycle that has already begun, press and hold the ON/OFF
button. The cycle will be stopped and the machine will switch o.
D
B
C
A
