Intermatic EK4537 Manual


Læs gratis den danske manual til Intermatic EK4537 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Intermatic EK4537, eller vil du spørge andre brugere om produktet?

Side 1/2
IMPORTANT OPERATING INSTRUCTIONS
1. Disconnect power.
2. Insert the photocontrol prongs into the female socket and twist in clock-wise direction until unit is secure.
3. If necessary, adjust the base so that the photocontrol eye is facing north away from the sun and any artificial light.
4. Reapply Power.
Instructions for installing photocontrols
WARNING
Disconnect power at the circuit breaker(s) or disconnect switch(es) before beginning installation or servicing.
Do NOT use the OFF state of the photocontrol for equipment servicing.
Neutral/L2
Line/L1
Receptacle
Photocontroller
Black
White
Red
Load
Neutre/L2
Ligne/L1
Prise
Unité de
commande
photo-
électronique
Noir
Blanc
Rouge
Charge
Neutral/L2
Línea/L1
Receptáculo
Control
fotoeléctrico
Negro
Blanco
Rojo
Carga
Federal Communications Commission (FCC) notice for EK, NF and LED models (ELC series does not require compliance with FCC regulations)
This Class A digital apparatus complies with ICES-005 of Canada.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may cause undesired operation.
INSTRUCTIONS D’UTILISATION IMPORTANTES
1. Débrancher l’alimentation.
2. Insérer les broches de la commande photo-électronique dans la prise femelle et tourner dans le sens horaire jusqu’à ce que l’unité soit bien fixée.
3. Au besoin, ajuster la base de manière à orienter la commande photo-électronique face au nord, à l’écart du soleil et de toute lumière artificielle.
4. Rétablir l’alimentation.
Instructions d’installation des commandes photo-électroniques
AVERTISSEMENT
Débrancher l’alimentation au niveau des disjoncteurs ou des sectionneurs avant de procéder à l’installation ou à l’entretien.
Ne PAS utiliser l’état ARRÊT de la commande photo-électronique pour travailler sur le matériel.
Risque d’incendie ou d’électrocution
Avis de la Commission rale des communications (FCC) pour les moles EK, NF et DEL (la rie ELC n’a pas besoin de suivre les normes FCC)
Cet appareil numérique de classeA est conforme à la normeICES-005 du Canada.
Ce dispositif est conforme à la section15 des glementations de la FCC. Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas causer
d’interférences nuisibles, et (2) cet appareil doit accepter toute autre interférence rue, y compris les interrences pouvant entraîner un fonctionnement non dési.
INSTRUCCIONES DE FUNCIONAMIENTO IMPORTANTES
1. Desconecte la alimentación eléctrica.
2. Inserte las clavijas del control fotoelectrónico en el tomacorriente y gírelo hacia la derecha hasta que la unidad quede firme.
3. En caso necesario, ajuste la base de modo que la mirilla del control fotoelectrónico apunte hacia el norte lejos del sol y de las luces artificiales.
4. Reanude la alimentación eléctrica.
Instrucciones para la instalación de controles fotoelectrónicos
ADVERTENCIA
Desconecte la alimentación eléctrica de los disyuntores o desconecte los interruptores antes de comenzar la instalación o el mantenimiento.
NO use el estado OFF (apagado) del control fotoelectrónico para realizar mantenimiento del equipo.
Riesgo de incendio o descarga eléctrica
Notificación de la Comisión Federal de Comunicaciones (FCC) para modelos EK, NF y LED (para la serie ELC, no se exige el cumplimiento de las normas de la FCC)
Este aparato digital de claseA cumple con la norma ICES-005 de Canadá.
Este dispositivo cumple con la Parte 15 de las normas de la FCC. El funcionamiento está sujeto a las dos condiciones siguientes: (1) este dispositivo no puede causar
interferencia perjudicial y (2) este dispositivo debe aceptar cualquier interferencia recibida, incluida la interferencia que podría causar un funcionamiento no deseado.


Produkt Specifikationer

Mærke: Intermatic
Kategori: Ikke kategoriseret
Model: EK4537

Har du brug for hjælp?

Hvis du har brug for hjælp til Intermatic EK4537 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Intermatic Manualer

Intermatic

Intermatic EK4536 Manual

12 November 2025
Intermatic

Intermatic LC4521C Manual

11 November 2025
Intermatic

Intermatic OP2GY24 Manual

8 November 2025
Intermatic

Intermatic OP2BK24 Manual

6 November 2025
Intermatic

Intermatic WP1250MXD Manual

5 November 2025
Intermatic

Intermatic OP2BK18 Manual

4 November 2025
Intermatic

Intermatic WP1030MXD Manual

4 November 2025
Intermatic

Intermatic OP5BK24 Manual

4 November 2025
Intermatic

Intermatic OP5GY24 Manual

4 November 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Topping

Topping DX5 Manual

4 December 2025
CyberPower

CyberPower GX150C2 Manual

4 December 2025
SPT

SPT SM-1024K Manual

4 December 2025
Novy

Novy 990037 Manual

4 December 2025
D&R

D&R Hybrid-2 Manual

4 December 2025
Iogear

Iogear GHDSW4K3 Manual

4 December 2025
Vevor

Vevor WK320016-1 Manual

4 December 2025
ELO

ELO E426554 Manual

4 December 2025