22
IMPORTANT SAFETY INSTRUCTIONS
Verify Line Voltage Before Use
The JBL BAR 800MK2 (soundbar, detachable speakers and
subwoofer) has been designed for use with 100-240 volt,
50/60 Hz AC current. Connection to a line voltage other than
that for which your product is intended can create a safety and
re hazard and may damage the unit. If you have any questions
about the voltage requirements for your specic model or about
the line voltage in your area, contact your retailer or customer
service representative before plugging the unit into a wall outlet.
Do Not Use Extension Cords
To avoid safety hazards, use only the power cord supplied
with your unit. We do not recommend that extension cords be
used with this product. As with all electrical devices, do not run
power cords under rugs or carpets, or place heavy objects on
them. Damaged power cords should be replaced immediately
by an authorized service center with a cord that meets factory
specications.
Handle the AC Power Cord Gently
When disconnecting the power cord from an AC outlet, always
pull the plug; never pull the cord. If you do not intend to use this
speaker for any considerable length of time, disconnect the plug
from the AC outlet.
Do Not Open the Cabinet
There are no user-serviceable components inside this product.
Opening the cabinet may present a shock hazard, and any
modication to the product will void your warranty. If water
accidentally falls inside the unit, disconnect it from the AC power
source immediately, and consult an authorized service center.
To protect battery lifespan, fully charge at least once every
3 months. Battery life will vary due to usage patterns and
environmental conditions.
Do not expose the JBL BAR 800MK2 SURROUND to liquids
without removing cable connection. Do not expose JBL BAR
800MK2 SURROUND to water while charging. It may result in
permanent damage to the speaker or power source.
Chemicals, salt or “foreign particles” in your pool or the ocean
can damage the waterproof seals or harm the connector surface
over time if not rinsed off after use. After a liquid spill or rinse,
do not charge your speaker until it’s completely dry and clean.
Charging when wet might damage your speaker.
When using an external adapter, the output voltage/current of
the external adapter should not exceed 5V/3A.
WARNING
DO NOT ATTEMPT TO OPEN, SERVICE, OR DISASSEMBLE
THE BATTERY | DO NOT SHORT CIRCUIT | MAY EXPLODE IF
DISPOSED OF IN FIRE | RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE | DISPOSE OR RECYCLE
USED BATTERIES ACCORDING TO THE INSTRUCTIONS
