JL Audio Stealthbox SB-H-ELMNT/10W3v3/BK Manual

JL Audio Ikke kategoriseret Stealthbox SB-H-ELMNT/10W3v3/BK

Læs gratis den danske manual til JL Audio Stealthbox SB-H-ELMNT/10W3v3/BK (11 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 38 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 19.5 anmeldelser. Har du et spørgsmål om JL Audio Stealthbox SB-H-ELMNT/10W3v3/BK, eller vil du spørge andre brugere om produktet?

Side 1/11
Stealthbox®
I N S T A L L A T I O N G U I D E
SB - H - E L M N T / 10 W 3 v2 / B K, J L AU D I O , In c 2 0 0 3 Sh e e t SKU # 0 1 1 1 8 3 Re v i s i o n 0 1 /1 5 / 2 0 0 4 Pag e 1
for the
SB-H-ELMNT/10W3v2/BK
(2003-Up Honda Element)
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thor-
oughly before beginning the project. It
will guide you step by step through the
installation. Several of the steps in this
process may require two people to
accomplish.
It is absolutely vital that the enclosure
be properly mounted to the vehicle
according to these instructions. Failure
to mount the enclosure properly pres-
ents two problems: 1) The sub-bass
performance will suffer due to the
movement of the enclosure caused by
the force exerted by the woofer(s) and
2) A loose enclosure presents a serious
safety hazard in the event of a collision
or sudden deceleration.
Please enjoy your JL Audio Stealthbox
responsibly.
STEP 1:
Remove the front passenger’s plas-
tic seat rail cover, located under and rear of
the seat. Remove the rear mounting bolts,
using a 14mm socket.
STEP 2:
With a 14mm socket, remove the
front mounting bolts and tilt the seat to the
back.
There will be enough slack in the wire, so you
do not have to disconnect it.
STEP 3:
Remove the OEM plastic woofer
cover, by pulling out plastic push clips that are
located on each side.
STEP 4:
With a 10mm socket, remove the
four bolts (two on each side) that secure the
OEM woofer enclosure to the under dash.
STEP 5:
On the driver’s side, disconnect the
gray plug.
STEP 6:
Locate the bracket that is mounted
to the floor with a pair of bolts. Use the mid-
dle non-used hole as a drilling guide.
With a1/2” drill bit, drill through floor.
START
HERE
Continued on Next Page
w w w . j l a u d i o . c o m
➔ ➔
➔ ➔
STEP 7: Mount the supplied L-bracket to the
driver’s side upper OEM woofer enclosure’s mount-
ing bolt hole (from STEP 4).Using the supplied
1/4” lock washer and 1/4” flat washer. Apply to the
factory moutning bolt that was removed from
STEP 4.
Using a 7/16” socket, securely tighten the bolt
assembly.
STEP 10: Place the Stealthbox into location.
Using the socket cup set screw as guide and place
through the drilled hole from STEP 6.
Cont.
From
Previous
Page
Continued on Next Page
STEP 8: Thread in the supplied socket cup set
screw into the Stealthbox, leaving about 1 3/4”
exposed. Make sure that the slotted end of the
threaded rod is exposed. Place the supplied spacer
onto socket cup screw.
Use a piece of tape to hold the spacer onto the
threaded rod.You can take off the tape, once the
Stealthbox is in lcoation.
STEP 11: While second person is holding the
Stealthbox into position (inside of vehicle). Place flat
washer, lock washer and nut onto the exposed
threaded rod and secure.
If the socket cup set screw does not have enough
length, back out the socket cup set screw from
inside of the Stealthbox.
Use silicon to weather proof the bolt assembly.
STEP 12: Use the supplied bolt, lock washer and
flat washer to secure driver’s side of the Stealthbox
to the L-bracket that was mounted in STEP 7.
STEP 9: Run speaker wire to the Stealthbox
location and attach to terminal.
*Check the woofer for proper operation.*
SB - H - E L M N T / 10 W 3 v2 / B K, J L AUD IO, I n c 2 0 0 3 Sh e e t SKU # 0 1 1 1 8 3 Re v i s i o n 0 1 / 1 5 / 2 0 0 4Pag e 2
w w w . j l a u d i o . c o m


Produkt Specifikationer

Mærke: JL Audio
Kategori: Ikke kategoriseret
Model: Stealthbox SB-H-ELMNT/10W3v3/BK

Har du brug for hjælp?

Hvis du har brug for hjælp til JL Audio Stealthbox SB-H-ELMNT/10W3v3/BK stil et spørgsmål nedenfor, og andre brugere vil svare dig