JUNG FM UD 20250 UP Manual

JUNG Smart hjem FM UD 20250 UP

Læs gratis den danske manual til JUNG FM UD 20250 UP (16 sider) i kategorien Smart hjem. Denne vejledning er vurderet som hjælpsom af 48 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 24.5 anmeldelser. Har du et spørgsmål om JUNG FM UD 20250 UP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/16

eNet radio dimming actuator 1-gang mini

Art. No. : FMUD20250UP

Operating instructions

1 Safety instructions

Electrical devices may only be mounted and connected by electrically skilled

persons.

Serious injuries, fire or property damage possible. Please read and follow manual fully.

Danger of electric shock. Always disconnect before carrying out work on the devise or

load. In so doing, take all the circuit breakers into account, which support dangerous

voltages to the device and or load.

Danger of electric shock. Device is not suitable for disconnection from supply voltage.

The load is not electrically isolated from the mains even when the device is switched off.

Risk of destruction if the set operating mode and load type do not match. Set correct

operating mode before connecting or exchanging the load.

Fire hazard. For operation with inductive transformers, each transformer must be fused

on the primary side in accordance with the manufacturer's instructions. Only safety

transformers according to EN 61558-2-6 may be used.

Do not connect any luminaire with integrated dimmers. Device can be damaged.

Do not connect any LED or compact fluorescent lamps that are not specifically suitable

for dimming. Device can be damaged.

These instructions are an integral part of the product, and must remain with the end

customer.

2 Device components

Figure 1: Front view

(1) Operating mode switch

(2) Button Prog

(3) Status LED

(4) Measuring points for voltage measurement, terminals rear-mounted

1/16

82580723

J0082580723 28.03.2017

3 Function

Intended use

- Switching and dimming of incandescent lamps, HV halogen lamps, electronic transformers

for halogen or LED lamps, dimmable inductive transformers for halogen or LED lamps, HV-

LED or compact fluorescent lamps

- Operation with suitable radio transmitters

- Mounting in appliance box according to DIN 49073 in combination with a suitable cover

- Installation in surface-mounted housing or panel-mounted housing (accessories) for

suspended ceilings

i If inductive or electronic transformers are connected, observe the data of the transformer

manufacturer on loads and the dimming principle.

i Depending on the design and power rating of the LED lamps, the connected load of the

specified values could vary.

i HV-LED and compact fluorescent lamps generate high pulsed currents, when they are

operated in the leading edge phase control.

i Dimming results and dimming quality could vary depending on cable lengths, grid

conditions and other influencing factors. We cannot assume any guarantee for the function,

dimming results and dimming quality in connection with LED lamps.

i When connecting dimmable LED lamps or compact fluorescent lamps, set the operating

mode that is suitable for this purpose.

Product characteristics

- Switch-on via bulb-preserving soft start

- Switch-on brightness can be saved permanently

- Minimum brightness can be saved permanently

- Scene operation possible

- Status indication with LED

- Status feedback to radio transmitter

- Switchable with buttonProg.

- Electronic short-circuit protection with permanent switch-off after 7 seconds at the latest

- Electronic over-temperature protection

- Automatic or manual setting of the dimming principle suitable for the load

i Flickering of the connected lamps due to undershoot of the specified minimum load or

through centralised pulses from the power stations. This does not represent any defect in

the device.

i Brief flickering upon load detection possible. No operation is possible during load detection.

i Power extension possible by means of power boosters. Do not connect any LED lamps or

compact fluorescent lamps in combination with power boosters.

Can be set with eNet server:

- Maximum brightness

- Dimming speed

- Switch-on delay / switch-off delay

- Dim up/dim down ramp

- Switch-off warning

- Operation locks

- Continuous on, Continuous off

- Hotel function

- Run-on time

- Light control

i When operating with the eNet Server, operation and signalling could vary from what is

described here.

Supplementary functions with eNet Server:

- Fully encrypted radio transmission (AES-CCM) from eNet Server software version 2.0

- Update of the device software

- Repeater function

- Reading of error memory

2/16

82580723

J0082580723 28.03.2017

eNet radio dimming actuator 1-gang mini

Produkt Specifikationer

Mærke:	JUNG
Kategori:	Smart hjem
Model:	FM UD 20250 UP
Bredde:	53 mm
Højde:	28 mm
Produktfarve:	Sort
Indbygget skærm:	Ingen
Produkttype:	Dæmpningsaktuator
Strømforbrug (standby):	0.5 W
Driftstemperatur (T-T):	-25 - 70 °C
LED-indikatorer:	Ja
Strømkilde type:	Vekselstrøm
Monteringstype:	Planmonteret
Maksimal udendørsinterval:	100 m
Indgangsspænding:	230 V
Kompatible produkter:	FM-EBG
Indgangsfrekvens:	50/60 Hz
Frekvens:	868 Mhz
Maksimal skiftekapacitet:	250 W
Sendereffekt:	20 mW